9999 BENDIX AUTOMATIC SLACK ADJUSTER Recall

Campaign:

11E011000 on 03/24/2011

Component:

Service brakes, air:slack adjusters:automatic

Manufactured:

10/14/2010 - 01/30/2011

Affected:

64

Defect:

Bendix is recalling certain gunite automatic slack adjusters manufactured from october 15, 2010, through january 31, 2011, repackaged as bendix brand, part numbers 974294, 974296, 977142, and 977143, and sold for use as aftermarket equipment to paccar parts distributors. one slack adjuster was sold to a mack distributor. due to an incomplete "knitting" of the iron at the time of casting, inadequate structural integrity of the slack adjuster housing can occur, which could cause the housing to break at the handle under normal operating loads.

Consequence:

If the slack adjuster housing were to break, the wheel brake to which the slack adjuster is attached would no longer function, causing the vehicle to have reduced braking capacity and, if mounted on the steer axle, the vehicle could pull to one side, possibly resulting in a crash.

Correction:

Bendix will notify owners of record and gunite will replace any affected slack adjusters free of charge. the safety recall began on april 4, 2011. owners may contact gunite at 1-812-962-5000 or bendix at 1-440-329-9000.

Notes:

Owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to <a href=http://www.safercar.gov>http://www.safercar.gov</a> .

9999 BENDIX AUTOMATIC SLACK ADJUSTER TSB

Bulletin:

TCH-005-013B

Component:

043200 service brakes, air:slack adjusters:automatic

Summary:

Bendix: information regarding guidelines for the push rods for bendix asa-5 and bendix versajust automatic slack adjusters usage with brake actuator push rod qualifications. *pe

Home | Privacy