2017 PREVOST X3VIP TSBs (34)
- Bulletin:
- MI16-17E
- Component:
- 112000 electrical system:alternator/generator/regulator
- Summary:
- This maintenance information explains how to remove and install the bosch hd10 (120a or 150a) alternator.
- Bulletin:
- IS-13169
- Component:
- 263000 forward collision avoidance: adaptive cruise control
- Summary:
- This instruction sheet explains how to install the aware adaptive cruise braking (acb) flr20 radar sensor replacement kits # 145372 and 145373
- Bulletin:
- MI16-10A
- Component:
- 020000 suspension
- Summary:
- This maintenance information applies only to vehicles equipped with 19000 lb independent front suspension (ifs) and 22.5 x 10.5 alcoa aluminum wheels for 365/70 r 22.5 size tires. when balancing this wheel for installation on the ifs, a spe
- Bulletin:
- Wb17-10A
- Component:
- 203000 wheels:lugs/nuts/bolts
- Summary:
- On the vehicles affected by this bulletin, inspect and re-torque the prevost slide-out rail bolts. if damaged, replace bolts.
- Bulletin:
- SP17-18
- Component:
- 114000 electrical system:wiring
- Summary:
- On the vehicles affected by this bulletin, remove relay r26, isolate and/or reconnect wires according to the wiring diagram d061670 p18.2 revision 8. also move water pump ground connection to the electronic ground pin a54 j2.14 and rename c
- Bulletin:
- MI16-05
- Component:
- 355200 equipment:other:owners/service/other manual
- Summary:
- This maintenance information shares information about the bendix m-32qr valve replaced by m-40qr model htat need to be taken into consideration, specially when switching them for the first time on a vehicle.
- Bulletin:
- MI16-16
- Component:
- 110000 electrical system
- Summary:
- This procedure explains how to perform a starter removal and installation, and does apply to melco 105p70 starter part number #21212425.
- Bulletin:
- MI16-15A
- Component:
- 199000 tires:pressure monitoring and regulating systems
- Summary:
- The beru sensors used on prevost vehicles to monitor tire pressure (tpms system) are being replaced by new huf sensors and their corresponding stainless valves stems. since the older and newer sensors are using different valve stems, repla
- Bulletin:
- MI16-15B
- Component:
- 351300 equipment:recreational vehicle:lpg tank valve/gauge
- Summary:
- The beru sensors used on prevost vehicles to monitor tire pressure (tpms system) are being replaced by new huf sensors and their corresponding stainless valves stems. since the older and newer sensors are using different valve stems, repla
- Bulletin:
- CK17-27
- Component:
- 356000 equipment adaptive
- Summary:
- This conversion kit explains how to to disable the acb radar.
- Bulletin:
- CK17-30
- Component:
- 118000 electrical system: software
- Summary:
- On the vehicles affected by this bulletin, it is now possible to replace the older generation tgw 2.0 (3g network) by the newer 2.1 version (4g the network) using accessory kit 23266301 and the following procedure.
- Bulletin:
- WB17-02
- Component:
- 060000 engine and engine cooling
- Summary:
- This bulletin explains how install an extension to the linear thermal detector (ltd) over the alternators
- Bulletin:
- Mi16-15
- Component:
- 199000 tires:pressure monitoring and regulating systems
- Summary:
- The beru sensors used on prevost vehicles to monitor tire pressure (tpms system) are being replaced by new huf sensors and their corresponding stainless valves stems. since the older and newer sensors are using different valve stems, repla
- Bulletin:
- MI17-22
- Component:
- 071100 fuel system, gasoline:storage:tank assembly
- Summary:
- This maintenance information explains how to inspect the fuel tank cradle mounting screws on a yearly basis
- Bulletin:
- IS-17016
- Component:
- 350000 equipment
- Summary:
- This instruciton sheet explains how to relocate the rv-3 valve
- Bulletin:
- IS-17071
- Component:
- 110000 electrical system
- Summary:
- This instruction sheet explains how to install an eld interface on obd vehicles
- Bulletin:
- IS-17907
- Component:
- 353000 equipment:electrical
- Summary:
- This instruction sheet explains how to install the volvo electronic logging device (eld)
- Bulletin:
- IS-13169A
- Component:
- 030000 brakes (pws)
- Summary:
- This instruction sheet explains how to install the aware adaptive cruise braking (acb) flr20 radar sensor replacement kits # 145372 and 145373
- Bulletin:
- MI15-24
- Component:
- 350000 equipment
- Summary:
- This maintenance information explains how to perform an inspection of the vehicle power cables. power cables in poor condition can be the cause of failures and serious damages in the engine compartment.
- Bulletin:
- IS-15907A
- Component:
- 020000 suspension
- Summary:
- This instruction sheet explains how to assemble the bendix flr10 and flr20 radar sensor alignment tool
- Bulletin:
- IS-18901
- Component:
- 060000 engine and engine cooling
- Summary:
- This instruction sheet explains how to install an engine belt guard
- Bulletin:
- MI16-17F
- Component:
- 111000 electrical system:battery
- Summary:
- This maintenance information explains how to remove and install the bosch hd10 (120a or 150a) alternators
- Bulletin:
- MI18-02
- Component:
- 060000 engine and engine cooling
- Summary:
- This mainteannce informaiton presents the latest engine oil & filter change intervals for the volvo engine
- Bulletin:
- IS-13009B
- Component:
- 017000 steering:linkages
- Summary:
- This instruction sheet explains how to install and adjust drag link # 660699
- Bulletin:
- IS-17905
- Component:
- 110000 electrical system
- Summary:
- This instruction sheet explains how to install an eld interface kit on pre-obd prevost vehicles equipped with volvo d13 engines
- Bulletin:
- MI18-16A
- Component:
- 112000 electrical system:alternator/generator/regulator
- Summary:
- This maintenance information presents guidelines to help with the diagnosis of the bosch hd10 alternators
- Bulletin:
- MI18-21
- Component:
- 353600 equipment:air conditioner
- Summary:
- This maintenance information presents information about the bitzer a/c compressor oil change interval and reminds technicians to clean the oil filter/strainer and the magnetic drain plug.
- Bulletin:
- IS-18901
- Component:
- 060000 engine and engine cooling
- Summary:
- This instruction sheet explains how to install the engine belt guard on x3 series vehicles with coolant system electrical fan drive.
- Bulletin:
- MI18-18
- Component:
- 354600 equipment:mechanical:wrecker and wheel lift devices
- Summary:
- This maintenance information explains how to tow and hoist prevost vehicles.
- Bulletin:
- MI16-17G
- Component:
- 060000 engine and engine cooling
- Summary:
- This maintenance information explains how to remove and install the bosch hd10 (120a or 150a) alternators
- Bulletin:
- MI18-18A
- Component:
- 350000 equipment
- Summary:
- This maintenance information explains how to tow and hoist prevost vehicles.
- Bulletin:
- MI18-21A
- Component:
- 060000 engine and engine cooling
- Summary:
- This maintenance information presents information about the bitzer a/c compressor oil change interval and reminds technicians to clean the oil filter/strainer and the magnetic drain plug.
- Bulletin:
- MI18-37
- Component:
- 103000 power train:automatic transmission
- Summary:
- This maintenance information presents information about the removal or installation of the lang kk73.1 electromagnetic clutch - part of the bitzer (model 4nfcy) air conditioning compressor.
- Bulletin:
- WB18-04
- Component:
- 118000 electrical system: software
- Summary:
- On the vehicles affected by this bulletin, update ems and acm software to the latest version available.
Home | Privacy