2014 PORSCHE 911 Recall
- Campaign:
- 14V698000 on 11/03/2014
- Component:
- Latches/locks/linkages:hood:latch
- Manufactured:
- 05/06/2014 - 09/22/2014
- Affected:
- 1,382
- Defect:
- Porsche cars north america, inc. (porsche) is recalling certain model year 2014-2015 porsche 911, boxster, and cayman vehicles manufactured may 7, 2014, to september 23, 2014. the front hood upper lock components were not manufactured to specification and may fail to securely latch the vehicle's hood during operation.
- Consequence:
- A failure of the hood latching mechanism may cause the hood to suddenly open during vehicle operation and will severely impede the driver's ability to see out the front windshield, increasing the risk of a vehicle crash.
- Correction:
- Porsche will notify owners, and dealers will replace the lock on the front hood, free of charge. the recall began december 12, 2014. owners may contact porsche customer service at 1-800-767-7243. porsche's number for this recall is ae04.
- Notes:
- Owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.safercar.gov.
2014 PORSCHE 911 TSBs (20)
- Bulletin:
- TI-19-14
- Component:
- 010000 steering
- Summary:
- Porsche: there is a software error message, immediately displayed, "fault rear steering possible to drive on", in the rear axle steering, after turning engine ignition on and would need to be reprogrammed. model 2014 911 turbo, 911 turbo
- Bulletin:
- TI-59-14
- Component:
- 110000 electrical system
- Summary:
- Porsche: according to new software, (version 2900), front end electronic control unit (front bcm) must be flashed, if rear end electronics control unit (rear bcm) needs replacing. model 2013-2014 911 991), boxster (981), cayman (981).
- Bulletin:
- 6689
- Component:
- 135000 visibility:rearview mirrors/devices
- Summary:
- Summary to be provided on a future date.
- Bulletin:
- 122-X7H3D-06
- Component:
- 063200 engine and engine cooling:exhaust system:manifold/header/muffler/tail pipe
- Summary:
- Concerns: tailpipe covers information: this is to inform you of a voluntary workshop campaign on the above-mentioned vehicles. there is a possibility that the fastening screw on the tailpipe covers on the affected vehicles was not tighten
- Bulletin:
- 122-M6M5Z-06
- Component:
- 341000 communications:horn assembly
- Summary:
- Concerns: horn (also referred to as fanfare) information: modified assignment of connector contacts due to installation of new type of horn. as a result, if the horn needs to be replaced, an adapter cable must also be installed.
- Bulletin:
- 122-N7A9G-06
- Component:
- 162300 structure:body:door
- Summary:
- Concerns: cover for door arrester information: this is to inform you of a voluntary workshop campaign on the above-mentioned vehicles. there is a possibility that covers for the door arresters that do not conform to the high quality standa
- Bulletin:
- 122-N5B2J-06
- Component:
- 110000 electrical system
- Summary:
- Concerns: rear-end electronics control unit information: this is to inform you of a voluntary workshop campaign on the above-mentioned vehicles. a new data record for the rear-end electronics control unit has been used during series produc
- Bulletin:
- 122-G7H3U-06
- Component:
- 117000 digital instrument panel
- Summary:
- Concerns: instrument cluster information: this is to inform you of a voluntary workshop campaign on the above-mentioned vehicles. the following fault symptoms can occur on the affected vehicles due to a software error in the instrument cl
- Bulletin:
- 122-H3A4J-06
- Component:
- 176100 latches/locks/linkages:hood:latch
- Summary:
- Concerns: upper part of lock on front lid information: this is to inform you of a recall campaign on the above-mentioned vehicles. due to a temporary manufacturing error, there is a possibility that front lid lock upper parts, on which th
- Bulletin:
- 122-E3L8H-03
- Component:
- 134000 visibility:sun roof assembly
- Summary:
- Cause: noises can be caused by excessive relative movements between the individual components. remedial action: rework sliding roof seal.
- Bulletin:
- 122-R7W2C-07
- Component:
- 111000 electrical system:battery
- Summary:
- Concerns: agm starter battery (referred to below simply as ?battery?) situation: customer complaints concerning battery-related topics recurring customer complaints concerning topics relating to battery capacity and quality.
- Bulletin:
- 122-N9Z4L-07
- Component:
- 111000 electrical system:battery
- Summary:
- Concerns: agm starter battery (referred to below simply as 'battery') situation: support for the care andmaintenance of the agmstarter battery (at the dealership): from the time the vehicle is delivered to the porsche centre until it is h
- Bulletin:
- 122-T7Y5Q-12
- Component:
- 110000 electrical system
- Summary:
- Information: this document updates information previously published in eq 1105, eq 1105, and eq 1401. to provide stable voltage and sufficient current throughout certain service operations, you should connect the vehicle to a battery charg
- Bulletin:
- 122-B9V4V-06
- Component:
- 355200 equipment:other:owners/service/other manual
- Summary:
- Information: the approval and support management system was created to offer assistance to the dealer organization with new and complex technical issues by utilizing the support specialists within porsche r&d. as a result, this process has
- Bulletin:
- 122-P5G7U-07
- Component:
- 070000 fuel system, gasoline
- Summary:
- Oil in the wiring harness. if oil is found in the engine wiring harness during a repair, the wiring harness and all the affected components (including the oil pump control valve) must be replaced.
- Bulletin:
- 122-P5G7U-07
- Component:
- 060000 engine (pws)
- Summary:
- Oil in the wiring harness. if oil is found in the engine wiring harness during a repair, the wiring harness and all the affected components (including the oil pump control valve) must be replaced.
- Bulletin:
- 122-S6R3L-08
- Component:
- 110000 electrical system
- Summary:
- Cause if the hall sensor is not positioned correctly or if it becomes slightly detached, there will be too much of a gap between the sensor and component and an error message will be displayed.
- Bulletin:
- 122-D7K9V-09
- Component:
- 060000 engine (pws)
- Summary:
- Complaint - incorrect allocation of fault code (p0153/p0133) for oxygen sensor (upstream of catalytic converter): replacing both oxygen sensors (upstreamof catalytic converter) (89/18)
- Bulletin:
- 122-Y9K4F-09
- Component:
- 200000 wheels
- Summary:
- Symptom: during and after race track use, loud noises can sometimes come from the wheel assembly on the rear axle - particularly on bends. cause: particles of dirt on the contact surfaces can cause micro-movements in the wheel assembly on
- Bulletin:
- 122-X4X7D-09
- Component:
- 060000 engine and engine cooling
- Summary:
- Cause the noises can occur if there is excessive spring force tolerance in the oil separator date of introduction the optimized oil separators are used in production from november 25, 2015. remedial action in the event of a customer co
Home | Privacy