1986 AUDI 5000 Recalls (9)
- Campaign:
- 86V103000 on 08/05/1986
- Component:
- Fuel system, gasoline:fuel injection system
- Manufactured:
- 07/31/1984 - 06/30/1986
- Affected:
- 80,710
- Defect:
- Misadjustment of fuel distributor allows fuel to escape and be absorbed by the air filter. consequence of defect: with the fuel absorbed by the air filter and an engine backfire on restart, this fuel could ignite and result in an engine compartment fire.
- Correction:
- Installation of an air filter modification kit to preclude fuel leaks.
- Notes:
- System: fuel/engine compartment.vehicle description: passenger cars.
- Campaign:
- 86V113000 on 09/01/1986
- Component:
- Seat belts:front:buckle assembly
- Manufactured:
- 01/31/1986 - 01/31/1986
- Affected:
- 8,000
- Defect:
- Rear or front right seat belt locks may not properly engage. consequence of defect: seat belts could separate in event of heavy brake application or impact and thus subject passengers to injury.
- Correction:
- Replace seat belts, as necessary.
- Notes:
- System: seat belt.vehicle description: passenger cars.
- Campaign:
- 87V009000 on 02/04/1987
- Component:
- Vehicle speed control:cruise control
- Manufactured:
- 07/31/1984 - 03/31/1986
- Affected:
- 81,000
- Defect:
- The idle stabilizer may experience excessive wear, causing engine idle fluctuations, usually described as engine surge, which increase with usage of the car.
- Consequence:
- Engine surge could ultimately see-saw to the extend thatloss of vehicle control could be experienced if the brakes were not applied intime. there is a risk of a collision and injury in a confined space.
- Correction:
- Replace idle stabilization valve.
- Notes:
- System: throttle/idle stabilizer.vehicle description: passenger vehicles with automatic transmission.
- Campaign:
- 87V008000 on 02/04/1987
- Component:
- Power train:automatic transmission:lever and linkage:floor shift
- Manufactured:
- 07/31/1977 - 06/30/1986
- Affected:
- 251,102
- Defect:
- Sudden acceleration from a stationary position may occur, when shifting from park to reverse or drive.
- Consequence:
- Unexpected sudden acceleration without prior warningcould result in a vehicle crash, causing injuries.
- Correction:
- Install an automatic shift lock to prevent the transmission shift lever from being moved from park to reverse or drive unless brake pedal is applied at the same time.
- Notes:
- System: transmission linkage.vehicle description: passenger vehicles with automatic transmission.
- Campaign:
- 87V157000 on 10/12/1987
- Component:
- Fuel system, gasoline:storage:tank assembly
- Manufactured:
- 07/31/1983 - 08/31/1987
- Affected:
- 25,000
- Defect:
- Repeated topping off of fuel tank during refueling reduces the expansion space within the tank allowing vapors to escape from the charcoal filter to outside rather than being inducted into the engine.
- Consequence:
- Escaping vapors could ignite by heat emitted by theexhaust system.
- Correction:
- Install redesigned filler neck and a new vent valve and hose for charcoal filter. also, stop refueling when pump nozzle shuts off.
- Notes:
- System: fuel tankvehicle description: turbo and turbo quattro passenger cars.
- Campaign:
- 87V158000 on 10/12/1987
- Component:
- Service brakes, air:disc:caliper
- Manufactured:
- 11/30/1985 - 11/30/1986
- Affected:
- 16,000
- Defect:
- Certain rear brake calipers could bind and consequently overheat.
- Consequence:
- Overheated calipers could cause brake pedal to feelspongy and could result in one brake circuit becoming inoperative. brakingability would be affected.
- Correction:
- Requires inspection of brake calipers and replacement of calipers as necessary.
- Notes:
- System: rear brake caliper.vehicle description: passenger cars
- Campaign:
- 89V006000 on 01/22/1989
- Component:
- Fuel system, gasoline
- Manufactured:
- 07/31/1983 - 10/31/1988
- Affected:
- 35,000
- Defect:
- Fuel injection seals may harden, due to high temperature and alcohol in some fuels, and allow fuel to escape into the engine compartment.
- Consequence:
- Fuel dripping onto hot engine components could cause anengine compartment fire.
- Correction:
- Replace engines fuel injector seals with improved seals plus improvements designed to better insulate the engine against fire risk.
- Notes:
- System: fuelvehicle description: passenger cars with turbo.
- Campaign:
- 93V006000 on 01/28/1993
- Component:
- Power train:axle assembly
- Manufactured:
- 09/30/1984 - 12/31/1990
- Affected:
- 152,000
- Defect:
- The differential oil of the transaxle is lost over time due to evaporation. low oil levels cause premature bearing and gear wear and eventual failure of the differential.
- Consequence:
- In the event of failure, the vehicle's drive wheels couldlose power. in extreme circumstances, the front wheels lock, causing rapiddeceleration resulting in possible loss of vehicle control and an accident.
- Correction:
- Drain and replace the differential gear oil with oil having higher performance characteristics.
- Notes:
- System: power train.vehicle description: passenger cars with automatic 3-speed transmissions.
- Campaign:
- 96E006000 on 03/11/1996
- Component:
- Service brakes, hydraulic:foundation components:hoses, lines/piping, and fittings
- Manufactured:
- 12/31/1986 - 11/30/1995
- Affected:
- 414
- Defect:
- These brake hose assemblies have inadequate crimps attaching the hose to the hose fittings and could cause the hose and fitting to separate.
- Consequence:
- If the brake hose assembly separates, loss of braking power can occur increasing the potential for a vehicle accident.
- Correction:
- These brake hose assemblies will be replaced.
- Notes:
- System: brakes; hydraulic; lines; hoses.equipment description: aftermarket brake hose assemblies, model sp6957, for use on 1983 through 1986 audi 5000 vehicles.note: the vehicle owner should immediately return the vehicle to the service facility which performed the installation and the installer shold remove the brake hose assembly and replace it with assembly sp9037.eis will remedy the defect without charge to the owner for the replacement of the defective parts and will pay the installing facility for its purchase cost of there placement part (a copy of the purchase invoice will be needed) plus a labor charge. owners or installers can contact eis at 129 worthington ridge, berlin, connecticut 06037, attn. d. j. duprey, quality assurance manager, or call1-203-828-8290. also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
Home | Privacy