1980 NISSAN 200SX Recall

Campaign:: 80V112000 on 10/15/1980
Component:: Vehicle speed control
Manufactured:: 02/28/1979 - 07/31/1980
Affected:: 39,382
Defect:: Moisture present in the exhaust gas recirculation system may, under conditions of sub-zero temperatures and low egr flow rate, condense and freeze in the throttle chamber. an icing condition could occur if the vehicle owner fails to adequately warm up the engine before driving. this could prevent the throttle from closing completely and would result in higher than norman idle rpm.
Correction:: The dealer will install a throttle chamber heating kit to prevent icing at no charge to owner.
Notes:: Vehicle description: passenger vehicles.system: throttle linkages and control; throttle chamber.consequences of defect: should a high idle condition occur when the roads arewet, or covered with snow and ice, hard braking could cause loss of vehiclecontrol and accident.

1980 NISSAN 200SX TSBs (3)

Bulletin:: NTB-09-030
Component:: 110000 electrical system
Summary:: Nissan: the 12 volt battery is an important part of the vehicle electrical system and is required to stay connected when the engine is running. to prevent damage to vehicle electronic components follow the instructions/cautions. no mod
Bulletin:: NTB-09-101
Component:: 199000 tires:pressure monitoring and regulating systems
Summary:: Nissan: tire pressure monitoring system (tpms) warning light on/flashing. no models or model years listed. *pe updated on 08-11-2011. *kb
Bulletin:: NTB-09-129
Component:: 355200 equipment:other:owners/service/other manual
Summary:: Nissan: vent control valve replacement. when replacing the evap canister vent control valve for reason: use the one listed on page 2; for vent control valve replacement procedure, refer to the appropriate section of the electronic service