9999 CUMMINS ISM CM876 Recalls (2)
- Campaign:
- 07E034000 on 06/10/2007
- Component:
- Engine and engine cooling:engine:diesel
- Affected:
- 782
- Defect:
- Certain cummins ism cm876 (epa-07) diesel engines produced for on highway vehicle applications from april 1, 2006, through march 21, 2007, with serial numbers ranging from 35157011 to 35192741. the electronic control module fails to recognize inputs of the vehicle electronic control unit or from a driver actuated dash switch thereby increasing the risk of unintended (or unexpected) elevated exhaust temperatures.
- Consequence:
- While this condition does not involve a risk of fire in the vehicle itself, it could present a fire hazard in a situation where the vehicle's exhaust is in close proximity to materials or substances that can melt, burn, or explode.
- Correction:
- Each vehicle manufacturer will notify owners of vehicles that contain these engines about this defect. cummins will conduct the remedy campaign and provide quarterly completion reports broken down by vehicle manufacturer; however the vehicle manufacturers will be responsible for the recall. vehicles will be repaired at no cost to the owner. the recall is expected to begin during june 2007. owners can contact either their vehicle manufacturer or cummins customer assistance center at 1-800-343-7357.
- Notes:
- Cummins recall number c0709.customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.safercar.gov.
- Campaign:
- 09E046000 on 07/20/2009
- Component:
- Engine and engine cooling:engine:diesel
- Manufactured:
- 03/08/2009 - 06/21/2009
- Affected:
- 912
- Defect:
- Cummins is recalling 912 isb cm2150, isc cm2150, isl cm2150, ism cm876, and isx cm871 model diesel engines installed as original equipment in various emergency vehicles. the vehicles may be designed with a hard wired, dash-mounted switch that enables the vehicle operator to inhibit aftertreatment diesel particulate filter regeneration in environments where the operator believes it may be unsafe for elevated exhaust temperatures. due to an issue with the logic in the ecm software in these engines, the switch may not function correctly, leading the operator to believe that the switch is in "inhibit" mode when it is not.
- Consequence:
- This condition will permit hot exhaust gases to exit the vehicle tailpipe, increasing the risk of melting or burning of nearby surfaces, or a fire.
- Correction:
- Each vehicle manufacturer will file a defect report and remedy plan for their vehicles which included these engines as original equipment. vehicles will be repaired by cummins at no cost to the owner. owners may contact either their vehicle manufacturer or cummins at 1-800-diesels (1-800-343-7357).
- Notes:
- Owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to <a href=http://www.safercar.gov>http://www.safercar.gov</a> .
9999 CUMMINS ISM CM876 TSBs (6)
- Bulletin:
- C0819
- Component:
- 061000 engine and engine cooling:engine
- Summary:
- Cummins: orion voltage regulator campaign. addressing a fuel lift pump voltage regulator issue. authorizes repair shop to remove cummins voltage regulator from wiring harness and install separate 12-vdc power source for orion bus applica
- Bulletin:
- DN-090006
- Component:
- 061200 engine and engine cooling:engine:diesel
- Summary:
- Cummins: inability to complete stationary regeneration. ineffective stationary regeneration occurs when the engine rpm increases, but the exhaust temperatures do not increase. model ism cm876, isx cm871. *pe
- Bulletin:
- SB-09T12-11
- Component:
- 061200 engine and engine cooling:engine:diesel
- Summary:
- Cummins engine: air compressor head replacement kit. various model engine. no model years listed. *pe
- Bulletin:
- EFN-E10058
- Component:
- 063130 engine and engine cooling:exhaust system:emission control:gas recirculation valve (egr valve)
- Summary:
- Cummins: egr cooler coolant return tube o ring; incorrect material specification. an o ring of incorrect material specification was installed on the exhaust gas recirculation (egr) cooler coolant return tube connection to the coolant head
- Bulletin:
- TSB-110260
- Component:
- 061000 engine and engine cooling:engine
- Summary:
- Cummins: without interaction or fault codes, the engine idles high from exhaust gas pressure sensor. *pe
- Bulletin:
- TSB-100890
- Component:
- 060000 engine (pws)
- Summary:
- Cummins: freezing may occur, in certain cold weather evironments and operating conditions, due to condensation in breather system affecting heavy duty applications that have external crankcase breather systems. models ism cm876, isx cm871
Home | Privacy