9999 BRUNO SCOOTER LIFTS (ALL) TSBs (13)
- Bulletin:
- SB-38
- Component:
- 350000 equipment
- Summary:
- Bruno: information provided regarding the replacement of control modules. *pe
- Bulletin:
- SB-57
- Component:
- 353000 equipment:electrical
- Summary:
- Bruno: information being provided regarding the removal and replacement of swing away. *pe
- Bulletin:
- SB-45
- Component:
- 353000 equipment:electrical
- Summary:
- Bruno: information provided regarding the replacement carony hardware for the rail positioning and retention. *pe
- Bulletin:
- SB-58
- Component:
- 161000 structure:frame and members
- Summary:
- Bruno: due to supplier welding out of normal welding process, a possibility of a weld is missing, and an inspection is required and if necessary, a service kit is available for repair. *pe
- Bulletin:
- SB-47
- Component:
- 350000 equipment
- Summary:
- Bruno: on the swing away, the unit's latch is hard to operate and may be damaged and would need to be inspected. *pe
- Bulletin:
- SB-50
- Component:
- 114000 electrical system:wiring
- Summary:
- Bruno: a small number of 17 foot wiring harnesses was shipped out rather than normal 23 foot wiring harnesses, due to supplier's error and work well for majority of vehicles but not long enough for installation of these lifts on full size
- Bulletin:
- SB-26
- Component:
- 356000 equipment adaptive
- Summary:
- Bruno: the snap ring groove, on mdc-12009 motors, holding output shaft in place, was not in tolerance and a possibility that snap ring will be loose and come out, jeopardizing lift's ability to hold a load. *pe
- Bulletin:
- SB-29
- Component:
- 350000 equipment
- Summary:
- Bruno: at time of assembly, between the hex head screw and the clevis pin, the hold tight strap may not been properly assembled and should be inspected. *pe
- Bulletin:
- DB-53
- Component:
- 350000 equipment
- Summary:
- Bruno: the actuator component hardware has loosened or has pulled out, due to an irregularity in the casting of the actuator and information is provided regarding the inspection of actuator and if necessary, to be replaced.
- Bulletin:
- SB-31
- Component:
- 350000 equipment
- Summary:
- Bruno: information provided regarding the inspection and maintenance of the buckle style docking devices and the visibility of tongue, if wear is shown or not smoothly functioning, then tongue would need to be replaced. *pe
- Bulletin:
- SB-59
- Component:
- 350000 equipment
- Summary:
- Bruno: informational procedure regarding the replacement and installation of the swing away due to a weld issue not visible to the eye. *pe
- Bulletin:
- SB-43
- Component:
- 350000 equipment
- Summary:
- Bruno: in curb sider or out rider installation kits, a few of the bolts failed to be treated to eliminate hydrogen embrittlement and the head may separate, under stress of clamp load, if not properly treated, when tightened in place.
- Bulletin:
- SB-36
- Component:
- 350000 equipment
- Summary:
- Bruno: the bolt spring hose tolerances can cause spring to bind and make unexpected noises, while lift operates correctly, but spring hose should be removed to eliminate binding. *pe
Home | Privacy