2017 HINO NJ8J TSBs (20)
- Bulletin:
- 167-T1702-05
- Component:
- 063000 engine and engine cooling:exhaust system
- Summary:
- Tt-17-009 beginning with 2017 model year, all hino vehicles are equipped with a particulate matter (pm) sensor near the exhaust exit. a ceramic sensing element is used in the pm sensor and can be damaged or broken if the sensor is dropped o
- Bulletin:
- 167-B0501-12
- Component:
- 060000 engine (pws)
- Summary:
- 05 - 011 corrections to workshop manuals for j08 engines. the standard gap between ends of the second piston ring and the oil ring.
- Bulletin:
- 167-B0502-12
- Component:
- 110000 electrical system
- Summary:
- Sb - 05 - 004 speedometer recalibration. this document is to inform of the procedure to calibrate the pulse adjust module whenneeded (ex. tire size change, rear carrier ratio change).
- Bulletin:
- 167-B0503-12
- Component:
- 060000 engine (pws)
- Summary:
- Sb ? 05 - 010 correction to workshop manuals for the j08e engine. a) resistance between terminals of the air intake pre-heater relay should be 64.0 ? 96.0 ohms b) illustration of the air intake pre-heater terminal should be revised. c) r
- Bulletin:
- 167-B0504-12
- Component:
- 063000 engine and engine cooling:exhaust system
- Summary:
- Sb - 05 - 003 this document is to inform dealers and workshops on procedures to activate exhaust brake operation.
- Bulletin:
- 167-B0505-12
- Component:
- 356000 equipment adaptive
- Summary:
- Sb ? 05 - 007 design change of water pipe for j08e
- Bulletin:
- 167-B0506-12
- Component:
- 060000 engine (pws)
- Summary:
- Sb ? 05 - 008 this document is to inform the dealers about the addition of the pressure sensor cover and related part for the j08e engine.
- Bulletin:
- 167-B0508-12
- Component:
- 106000 power train:axle assembly
- Summary:
- Sb - 05 - 005 proper maintenance procedures for grease lubricated front axles
- Bulletin:
- 167-B0601-12
- Component:
- 060000 engine and engine cooling
- Summary:
- Sb ? 06 - 001 design change of engine oil cooler housing. the casting for the engine oil cooler housing has been revised to include 2 shallow machined grooves on both sides of the engine oil cooler housing. these grooves aid in the retentio
- Bulletin:
- 167-B0602-12
- Component:
- 061320 engine and engine cooling:engine:other fuel types:turbo-charger
- Summary:
- Sb ? 06 - 002 fuel filter usage. this bulletin provides technical information for proper fuel filter usage as well as an example of damage caused by foreign material allowed to enter the fuel system as a result of using an improper fuel fil
- Bulletin:
- 167-B0803-12
- Component:
- 203000 wheels:lugs/nuts/bolts
- Summary:
- Sb - 08 - 005 this document is to inform dealers and workshops of the design change to the hood damper, support bolt and the addition of a support collar.
- Bulletin:
- 167-B1503-12
- Component:
- 355200 equipment:other:owners/service/other manual
- Summary:
- Sb-15-002 correction of workshop manual for 2013 - 2015my (revision of troubleshooting procedure for the dtc p2123)
- Bulletin:
- 167-B1504-12
- Component:
- 355200 equipment:other:owners/service/other manual
- Summary:
- Sb-15-003 correction of workshop manual for hino 2015my (revision of troubleshooting procedure for the dtc p0421)
- Bulletin:
- 167-B1605-12
- Component:
- 118000 electrical system: software
- Summary:
- Sb-16-012 in the event that a subject vehicle exhibits a (mil) malfunction indicator lamp and a p0300 (all injector misfire) is stored in the engine ecu, enhanced ecu software is available to correct this concern.
- Bulletin:
- 167-B1621-12
- Component:
- 355200 equipment:other:owners/service/other manual
- Summary:
- Sb-16-010 correction of the inspection of the dpr filter.
- Bulletin:
- 167-B1307-12
- Component:
- 103300 power train:automatic transmission:gear position indication (prndl)
- Summary:
- 13-008 design change of the idler gear case and idler gear bolt. abnormal load such as a stuck supply pump was applied to gear train then causing the bolt to loosen. therefore, an enhancement to the case and bolt were carried out. the idle
- Bulletin:
- 167-B1312-12
- Component:
- 355200 equipment:other:owners/service/other manual
- Summary:
- Sb-13-009 this bulletin is to inform dealers and workshops of proper paint codes for all hino models. all models
- Bulletin:
- 167-R1701-11
- Component:
- 118000 electrical system: software
- Summary:
- The engine ecu (engine control unit) on all 2016my-2018my trucks contained in dealer inventory need to be reprogrammed prior to delivery. subject vehicles contain an error in the def monitoring program. to eliminate this situation, it is
- Bulletin:
- 167-R1702-11
- Component:
- 118000 electrical system: software
- Summary:
- The engine ecu (engine control unit) on all 2016my-2018my trucks contained in dealer inventory need to be reprogrammed prior to delivery. subject vehicles contain an error in the def monitoring program. to eliminate this situation, it is
- Bulletin:
- 167-B1702-11
- Component:
- 355200 equipment:other:owners/service/other manual
- Summary:
- All 16my-18my units that have been sold and are in service today will be addressed with a future campaign once the proper agencies have been notified and approval is received.
Home | Privacy