2015 HINO NJ8J TSBs (36)

Bulletin:
167-T1701-03
Component:
111000 electrical system:battery
Summary:
Beginning with the 2017 model year, hino changed the standard battery from a group 27 to a group 31. in the event that a group 27 battery must be replaced, it is recommended to use the group 31 as the service replacement for 2014my and newe
Bulletin:
167-R1701-03
Component:
060000 engine (pws)
Summary:
17my vehicles contain the function to monitor pm sensor performance, however because the threshold for detection logic is not appropriate, the engine ecu may not detect a malfunction of the pm sensor. the following procedure provides direct
Bulletin:
167-B0501-12
Component:
060000 engine (pws)
Summary:
05 - 011 corrections to workshop manuals for j08 engines. the standard gap between ends of the second piston ring and the oil ring.
Bulletin:
167-B0502-12
Component:
110000 electrical system
Summary:
Sb - 05 - 004 speedometer recalibration. this document is to inform of the procedure to calibrate the pulse adjust module whenneeded (ex. tire size change, rear carrier ratio change).
Bulletin:
167-B0503-12
Component:
060000 engine (pws)
Summary:
Sb ? 05 - 010 correction to workshop manuals for the j08e engine. a) resistance between terminals of the air intake pre-heater relay should be 64.0 ? 96.0 ohms b) illustration of the air intake pre-heater terminal should be revised. c) r
Bulletin:
167-B0504-12
Component:
063000 engine and engine cooling:exhaust system
Summary:
Sb - 05 - 003 this document is to inform dealers and workshops on procedures to activate exhaust brake operation.
Bulletin:
167-B0505-12
Component:
356000 equipment adaptive
Summary:
Sb ? 05 - 007 design change of water pipe for j08e
Bulletin:
167-B0506-12
Component:
060000 engine (pws)
Summary:
Sb ? 05 - 008 this document is to inform the dealers about the addition of the pressure sensor cover and related part for the j08e engine.
Bulletin:
167-B0508-12
Component:
106000 power train:axle assembly
Summary:
Sb - 05 - 005 proper maintenance procedures for grease lubricated front axles
Bulletin:
167-B0601-12
Component:
060000 engine and engine cooling
Summary:
Sb ? 06 - 001 design change of engine oil cooler housing. the casting for the engine oil cooler housing has been revised to include 2 shallow machined grooves on both sides of the engine oil cooler housing. these grooves aid in the retentio
Bulletin:
167-B0602-12
Component:
061320 engine and engine cooling:engine:other fuel types:turbo-charger
Summary:
Sb ? 06 - 002 fuel filter usage. this bulletin provides technical information for proper fuel filter usage as well as an example of damage caused by foreign material allowed to enter the fuel system as a result of using an improper fuel fil
Bulletin:
167-B0803-12
Component:
203000 wheels:lugs/nuts/bolts
Summary:
Sb - 08 - 005 this document is to inform dealers and workshops of the design change to the hood damper, support bolt and the addition of a support collar.
Bulletin:
167-T0610-12
Component:
110000 electrical system
Summary:
06 - 002 no throttle response. once a burnt out tail lamp filament touches a stop lamp filament, the current goes thru the stop lamp circuit causing the ecu to think that the brakes are applied. therefore stopping acceleration control.
Bulletin:
167-R1407-12
Component:
030000 service brakes, hydraulic
Summary:
T0280 during installation of the air pressure sensors on the air tanks, it is possible that they could have been damaged causing incorrect air pressure readings.
Bulletin:
167-B1418-12
Component:
118000 electrical system: software
Summary:
Sb-14-012 a subject vehicle may exhibit an illuminated check engine lamp with dtc (diagnostic trouble code) p0421 (catalyst efficiency below threshold). the engine ecu may falsely detect an issue with the atc (after turbo catalyst) with the
Bulletin:
167-B1423-12
Component:
118000 electrical system: software
Summary:
Sb-14-005 2011my-2015my conventional keyless entry programming
Bulletin:
167-B1418-12
Component:
118000 electrical system: software
Summary:
Sb-14-012 a subject vehicle may exhibit an illuminated check engine lamp with dtc (diagnostic trouble code) p0421 (catalyst efficiency below threshold). the engine ecu may falsely detect an issue with the atc (after turbo catalyst) with the
Bulletin:
167-B1423-12
Component:
353000 equipment:electrical
Summary:
Sb-14-005 2011my-2015my conventional keyless entry programming
Bulletin:
167-B1426-12
Component:
162810 structure:body:hood:hinge and attachments
Summary:
Sa-14-026 the broken hood grille procedure (sb-14-020) has been revised to reuse the grille nuts (sz17906009) if possible. there is a limited quantity of the nuts available and it has been confirmed that the nuts are reusable. the revised p
Bulletin:
167-B1503-12
Component:
355200 equipment:other:owners/service/other manual
Summary:
Sb-15-002 correction of workshop manual for 2013 - 2015my (revision of troubleshooting procedure for the dtc p2123)
Bulletin:
167-B1504-12
Component:
355200 equipment:other:owners/service/other manual
Summary:
Sb-15-003 correction of workshop manual for hino 2015my (revision of troubleshooting procedure for the dtc p0421)
Bulletin:
167-B1510-12
Component:
063130 engine and engine cooling:exhaust system:emission control:gas recirculation valve (egr valve)
Summary:
Sb-15-010 some vehicles that operate in extreme cold weather climates may exhibit ice accumulation on the egr (exhaust gas recirculation) butterfly plate with a repeat p1604 dtc (diagnostic trouble code) stored in the engine ecu. a heated e
Bulletin:
167-B1511-12
Component:
011000 steering:wheel and handle bar
Summary:
Sb-15-011 the following tsb (technical service bulletin) outlines the inspection method for steering wheel free play and the adjustment procedure of the steering gear.
Bulletin:
167-B1515-12
Component:
063200 engine and engine cooling:exhaust system:manifold/header/muffler/tail pipe
Summary:
Sb-15-016 new parts are available to prevent repeat exhaust manifold stud failures on the j05 engine. this bulletin provides instructions for installing longer manifold studs at the #4 cylinder location.
Bulletin:
167-B1523-12
Component:
060000 engine and engine cooling
Summary:
Sb-15-026 a subject vehicle may exhibit an engine oil leak or engine coolant leaking externally from the engine head gasket sealing area on the exhaust manifold side of the engine. an improved head gasket has been made available as a servic
Bulletin:
167-B1527-12
Component:
353000 equipment:electrical
Summary:
Sb-15-030 on subject vehicles, the mil (malfunction indicator lamp) may illuminate with dtc (diagnostic trouble code) u02a2 stored in the engine ecu. this may be due to a malfunction of the def (diesel exhaust fluid) tank sensor assembly. p
Bulletin:
167-B1528-12
Component:
353000 equipment:electrical
Summary:
Sb-15-031 foreign debris in the def (diesel exhaust fluid) tank may cause the scr (selective catalyst reduction) system to malfunction. this can result in dtc?s (diagnostic trouble codes) p20e8 or p20e9 - def pressure abnormality. an inlet
Bulletin:
167-B1616-12
Component:
060000 engine (pws)
Summary:
sb-16-004 1. in the event that a subject vehicle exhibits an illuminated check engine lamp and dtc?s p2201, p2214, p206b, p207f, or p20ee are stored in the dcu, the nox sensor may have failed due to a cracked nox sensor heating element. fo
Bulletin:
167-B1621-12
Component:
355200 equipment:other:owners/service/other manual
Summary:
Sb-16-010 correction of the inspection of the dpr filter.
Bulletin:
167-B1623-12
Component:
060000 engine (pws)
Summary:
sb-16-019 an enhanced fuel cut valve is available to address a potential sticking condition that results in excess residual pressure in the dosing injector (7thinjector) supply pipe. a sticking fuel cut valve may result in the following dt
Bulletin:
167-R1603-12
Component:
063000 engine and engine cooling:exhaust system
Summary:
scb-001-16 a subject vehicle may exhibit an illuminated check engine lamp with dtc (diagnostic trouble code) p14bf ?egr (exhaust gas recirculation) valve controller temperature sensor 1, 2 rationality. the egr valve may falsely detect this
Bulletin:
167-B1307-12
Component:
103300 power train:automatic transmission:gear position indication (prndl)
Summary:
13-008 design change of the idler gear case and idler gear bolt. abnormal load such as a stuck supply pump was applied to gear train then causing the bolt to loosen. therefore, an enhancement to the case and bolt were carried out. the idle
Bulletin:
167-B1312-12
Component:
355200 equipment:other:owners/service/other manual
Summary:
Sb-13-009 this bulletin is to inform dealers and workshops of proper paint codes for all hino models. all models
Bulletin:
167-T0706-12
Component:
355200 equipment:other:owners/service/other manual
Summary:
07 - 006 voltage drop test
Bulletin:
167-T1513-12
Component:
100000 power train
Summary:
Tt-15-014 the transmission dtc?s p0974 and p0986, may be found on 12my-15my coe models. there could also be a complaint of low power and erratic shifting. these diagnostic codes may be set due to low voltage between the transmission case an
Bulletin:
167-T1514-12
Component:
162000 structure:body
Summary:
Tt-15-016 the purpose of this publication is to communicate the standard measuring positions on the hino chassis. in some cases, the customer may report a visual chassis posture concern where the chassis appears to be leaning more towards t

Home | Privacy