2010 TESLA ROADSTER2 Recall
- Campaign:
- 10V458000 on 10/05/2010
- Component:
- Electrical system:battery:cables
- Manufactured:
- 05/31/2010 - 09/29/2010
- Affected:
- 439
- Defect:
- Tesla is recalling certain model year 2010 roadster 2.0 and 2.5 vehicles equipped with a 12v auxiliary cable. the 12v auxiliary cable for the low voltage back up power system may be improperly routed. if the wire is improperly routed, and trapped against the wheel well cover, the wire may abrade against the edge of the carbon fiber armature and, over time, expose the wire. contact between the bare wire and carbon fiber may cause a short-circuit leading to possible electrical arching.
- Consequence:
- Short circuit and electrical arcing could lead to a fire in the right front headlamp area.
- Correction:
- Tesla motors will check the routing of the 12v auxiliary cable and install a protective sleeve over the wire free of charge. this will prevent misrouting and pinching by the wheel well cover. the safety recall began on october 31, 2010. owners may contact tesla customer service at 877-888-3752.
- Notes:
- Owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to <a href=http://www.safercar.gov>http://www.safercar.gov</a> .
2010 TESLA ROADSTER2 TSBs (16)
- Bulletin:
- TSB-10-17-003
- Component:
- 061000 engine and engine cooling:engine
- Summary:
- Tesla: intermittent no start or charge. the implementation of a simple fix for a power drain caused by the immobilizer system which results in a contractor power fault in e.u. 2.0 power train vehicles. the fix is an adapter which plugs
- Bulletin:
- TSB-10-47-006
- Component:
- 105000 power train:driveline
- Summary:
- Tesla: drive button modification; incorrect drive buttons installed. a number of vehicles have been fitted with incorrect drive buttons. the suspect part causes an intermittent failure and lockup of all shift functions when the drive butt
- Bulletin:
- TSB-10-17-005
- Component:
- 111000 electrical system:battery
- Summary:
- Tesla: updated-switchpack not charging auxiliary battery; switchpack charge circuit malfunction prevents auxiliary battery from charging. some vehicles may experience a malfunction of the charging circuit in the switchpack which may resul
- Bulletin:
- TSB-10-16-010
- Component:
- 980000 unknown or other
- Summary:
- Tesla: there are revised torque specifications for the bolts on the battery pack cover. *rm
- Bulletin:
- TSB-10-34-011
- Component:
- 356000 equipment adaptive
- Summary:
- Tessla: on 2010 roadsters there is a chance that a tpms antenna may not be fully connected which can cause a blank reading on the touch screen. *rm
- Bulletin:
- TSB-10-10-012
- Component:
- 162300 structure:body:door
- Summary:
- Tessla: some door switch plates are made of mild steel instead of stainless steel which will cause it to deform and become inoperative. *rm
- Bulletin:
- TSB-09-15-007
- Component:
- 356000 equipment adaptive
- Summary:
- Tesla: floor mats were not anchored to the floor. they have not interfered with the operation, but are a nuisance. *rm
- Bulletin:
- SVC-11-17-011
- Component:
- 061000 engine and engine cooling:engine
- Summary:
- Tesla motors: roadster 2010-2011. there is water entry through the hood release cable grommet. *rm
- Bulletin:
- SVC-11-16-013
- Component:
- 111100 electrical system:battery:cables
- Summary:
- Tesla: during normal operation of vehicle, aps cable grommet can become dislodged. to improve security against water ingress a new design has been provided. *pe
- Bulletin:
- SVC-11-40-015
- Component:
- 061000 engine and engine cooling:engine
- Summary:
- Tesla: information regarding the motor and pem fans where certain types of weather conditions, such as snow, may accumulate too close and cause adverse affect on the airflow and cooling efficiency. this may shortened the useful life of
- Bulletin:
- SVC-11-40-014
- Component:
- 061000 engine and engine cooling:engine
- Summary:
- Tesla: information provided in regards to assembling a new sealed bearing dual pem/motor fan that is retrofit dual design to replace two separate fans with a single assembly to improve reliability and function in adverse weather condition
- Bulletin:
- SB-12-46-001
- Component:
- 111000 electrical system:battery
- Summary:
- Tesla motors: during the shipment of battery pack sheets, residual coolant may leak effecting shipping container integrity. *pe
- Bulletin:
- TSB-10-17-004
- Component:
- 110000 electrical system
- Summary:
- Tesla: condenser fan fuse upgrade. upgrading to 30 amps and installing a new label on the fuse box door to reflect upgrade. *js
- Bulletin:
- TN-13-16-002
- Component:
- 111000 electrical system:battery
- Summary:
- Tesla: when removing the battery pack these procedures need to be followed in order to ensure proper sealing of the hv rapid mate. no model or model years given. *js
- Bulletin:
- TN-13-44-003
- Component:
- 111000 electrical system:battery
- Summary:
- Tesla: the high voltage interlock loop (hvil) diagnostic guide. this is not an official bulletin. no model types or model years were provided. *js updated 10/21/14. *pe
- Bulletin:
- TN-13-44-001
- Component:
- 111000 electrical system:battery
- Summary:
- Tesla: due to isolation of model s high voltage, a monitor is installed in battery to ensure no electrical current, between vehicle and high voltage conductor, is being carried and is measured, periodically, for resistance between high vol
Home | Privacy