2009 TESLA ROADSTER TSBs (15)
- Bulletin:
- TSB-09-10-001
- Component:
- 162300 structure:body:door
- Summary:
- Tesla: leak point around door hinge. there is potential for water to ingress into the forward sill cavity of the body side panel. *pe
- Bulletin:
- RCL-09-31-001
- Component:
- 036500 service brakes, hydraulic:antilock:wheel speed sensor
- Summary:
- Tesla: some vehicles have been identified where the rear hub flange bolts have been undertorqued. this issue applies only to the rear hub assembly. the rear hub flange bolts on some of these vehicles are under torqued and may become loose.
- Bulletin:
- SB-09-31-002
- Component:
- 021700 suspension:front:hub
- Summary:
- Tesla: front/rear hub upright assembly. inspect both the front/rear-left and right hub-upright assemblies for torque mark alignment. *pe
- Bulletin:
- SB-09-15-004
- Component:
- 111000 electrical system:battery
- Summary:
- Tesla: potential no start condition or failed heater operation due to faulty components in ptc heater board. some hvac 400v controllers may have incorrect components installed on the ptc controller board. the board controls the heater opera
- Bulletin:
- TSB-09-16-008
- Component:
- 111000 electrical system:battery
- Summary:
- Tesla: inspection, prevention and repair of battery pack water ingress from the aps grommet. aps cable grommet on battery pack may become dislodged. the weight of the aps cable strains the j3 aps harness such that the pass through gromme
- Bulletin:
- TSB-10-16-010
- Component:
- 980000 unknown or other
- Summary:
- Tesla: there are revised torque specifications for the bolts on the battery pack cover. *rm
- Bulletin:
- TSB-09-15-007
- Component:
- 356000 equipment adaptive
- Summary:
- Tesla: floor mats were not anchored to the floor. they have not interfered with the operation, but are a nuisance. *rm
- Bulletin:
- SVC-11-17-011
- Component:
- 061000 engine and engine cooling:engine
- Summary:
- Tesla motors: roadster 2010-2011. there is water entry through the hood release cable grommet. *rm
- Bulletin:
- SVC-11-16-013
- Component:
- 111100 electrical system:battery:cables
- Summary:
- Tesla: during normal operation of vehicle, aps cable grommet can become dislodged. to improve security against water ingress a new design has been provided. *pe
- Bulletin:
- SVC-11-40-015
- Component:
- 061000 engine and engine cooling:engine
- Summary:
- Tesla: information regarding the motor and pem fans where certain types of weather conditions, such as snow, may accumulate too close and cause adverse affect on the airflow and cooling efficiency. this may shortened the useful life of
- Bulletin:
- SVC-11-40-014
- Component:
- 061000 engine and engine cooling:engine
- Summary:
- Tesla: information provided in regards to assembling a new sealed bearing dual pem/motor fan that is retrofit dual design to replace two separate fans with a single assembly to improve reliability and function in adverse weather condition
- Bulletin:
- SB-12-46-001
- Component:
- 111000 electrical system:battery
- Summary:
- Tesla motors: during the shipment of battery pack sheets, residual coolant may leak effecting shipping container integrity. *pe
- Bulletin:
- TN-13-16-002
- Component:
- 111000 electrical system:battery
- Summary:
- Tesla: when removing the battery pack these procedures need to be followed in order to ensure proper sealing of the hv rapid mate. no model or model years given. *js
- Bulletin:
- TN-13-44-003
- Component:
- 111000 electrical system:battery
- Summary:
- Tesla: the high voltage interlock loop (hvil) diagnostic guide. this is not an official bulletin. no model types or model years were provided. *js updated 10/21/14. *pe
- Bulletin:
- TN-13-44-001
- Component:
- 111000 electrical system:battery
- Summary:
- Tesla: due to isolation of model s high voltage, a monitor is installed in battery to ensure no electrical current, between vehicle and high voltage conductor, is being carried and is measured, periodically, for resistance between high vol
Home | Privacy