2009 HINO NJ8J Recalls (4)

Campaign:
08V667000 on 12/15/2008
Component:
Suspension:rear
Manufactured:
10/21/2007 - 09/03/2008
Affected:
130
Defect:
Hino is recalling 130 my 2008-2009 nd8j, ne8j, nj8j, and nv8j conventional trucks. the rear axle u-bolts were not properly tightened. the lower spring seat may not contact the axle housing properly, producing a gap on the front or rear side of the axle housing.
Consequence:
This gap could allow the u-bolts to loosen and/or cause the lower spring seat to crack. the axle could become misaligned and/or separated from the mountings increasing the risk of a crash.
Correction:
Dealers will inspect the rear air suspension lower spring seat for a gap between the rear axle and lower spring seat. the u-bolts will be tightened to the specified torque. the recall began on january 19, 2009. owners may contact hino at 1-248-699-9330.
Notes:
Hino recall no. m0140.customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to <a href=http://www.safercar.gov>http://www.safercar.gov</a> .
Campaign:
10V156000 on 04/15/2010
Component:
Engine and engine cooling:exhaust system
Manufactured:
07/15/2008 - 06/10/2009
Affected:
89
Defect:
Hino is recalling certain trucks with vertical exhaust pipes. certain bolts attaching the exhaust system to the truck may not have been properly tightened during the manufacturing process. the bolts could fail allowing the exhaust system to separate from the truck.
Consequence:
The exhaust system could fall onto the roadway and be struck by a following vehicle resulting in a crash.
Correction:
Hino will notify owners and dealers will repair the vehicles free of charge. the safety recall began on november 9, 2010. owners may contact hino at 248-699-9330.
Notes:
Hino recall no. m0180.owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to <a href=http://www.safercar.gov>http://www.safercar.gov</a> .
Campaign:
12V555000 on 12/03/2012
Component:
Electrical system:battery:cables
Manufactured:
08/17/2003 - 11/15/2011
Affected:
35,142
Defect:
Hino is recalling certain model year 2005 through 2013 medium duty trucks, models na6j, nb6j, nc6j, nd8j, ne8j, nj8j, nf8j, and nv8j, manufactured from august 18, 2003, through november 16, 2011. over time, the main b+ circuit from the battery to the starter could potentially short to ground due to wear that accumulates as a result of interference between the b+ circuit and its convoluted tubing sheath.
Consequence:
If the b+ circuit shorts to ground, it may lead to a fire.
Correction:
Hino will notify owners, and dealers will repair the vehicles free of charge. the recall began on january 17, 2013. owners may contact hino at 1-248-699-9390.
Notes:
Hino's recall campaign number is a8310.owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.safercar.gov.
Campaign:
12V555000 on 12/03/2012
Component:
Electrical system:wiring
Manufactured:
08/17/2003 - 11/15/2011
Affected:
35,142
Defect:
Hino is recalling certain model year 2005 through 2013 medium duty trucks, models na6j, nb6j, nc6j, nd8j, ne8j, nj8j, nf8j, and nv8j, manufactured from august 18, 2003, through november 16, 2011. over time, the main b+ circuit from the battery to the starter could potentially short to ground due to wear that accumulates as a result of interference between the b+ circuit and its convoluted tubing sheath.
Consequence:
If the b+ circuit shorts to ground, it may lead to a fire.
Correction:
Hino will notify owners, and dealers will repair the vehicles free of charge. the recall began on january 17, 2013. owners may contact hino at 1-248-699-9390.
Notes:
Hino's recall campaign number is a8310.owners may also contact the national highway traffic safety administration vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to www.safercar.gov.

2009 HINO NJ8J TSBs (35)

Bulletin:
C-0005
Component:
022400 suspension:rear:shock absorber
Summary:
Hino trucks: incorrect shock absorbers on rear air suspensions. incorrect length shock absorbers may have been installed on the rear, driver and or passenger sides of subject trucks. *pe
Bulletin:
SB-R-0029
Component:
092200 fuel system, other:delivery:hoses, lines/piping, and fittings
Summary:
Hino trucks: the fuel tank breather hose(s) has been modified to prevent water from entering into the fuel tank(s). *pe
Bulletin:
SB-R-0030
Component:
090000 fuel system, other
Summary:
Hino truck: abnormal noise and vibration within the engine occurs due to the impeded operation of the injector needle which is caused by the formation of deposits in the fuel. *pe
Bulletin:
SB-R-0033
Component:
090000 fuel system, other
Summary:
Hino truck: the davco fuel filter assembly has been improved to prevent the effusion of air into the fuel system. *pe
Bulletin:
SB-R-0034
Component:
061000 engine and engine cooling:engine
Summary:
Hino trucks: abnormal noise and vibration within the engine occurs due to the impeded operation of the injector needle which is caused by the formation of deposits in the fuel. *pe
Bulletin:
SL-R-0031
Component:
092200 fuel system, other:delivery:hoses, lines/piping, and fittings
Summary:
Hino trucks: abnormal noise and vibration within the engine occurs due to the impeded operation of the injector needle which is caused by the formation of deposits in the fuel. *pe
Bulletin:
167-P0803-12
Component:
060000 engine (pws)
Summary:
Ptb 01-08 complete engine assembly part numbers
Bulletin:
167-P1602-12
Component:
060000 engine (pws)
Summary:
13-008 injection pump drive case. please note the following part number changes to the injection pump bearing case. not replacing the correct replacement parts will result in major engine damage. the hino ordering system has been modified
Bulletin:
167-B0501-12
Component:
060000 engine (pws)
Summary:
05 - 011 corrections to workshop manuals for j08 engines. the standard gap between ends of the second piston ring and the oil ring.
Bulletin:
167-B0502-12
Component:
110000 electrical system
Summary:
Sb - 05 - 004 speedometer recalibration. this document is to inform of the procedure to calibrate the pulse adjust module whenneeded (ex. tire size change, rear carrier ratio change).
Bulletin:
167-B0503-12
Component:
060000 engine (pws)
Summary:
Sb ? 05 - 010 correction to workshop manuals for the j08e engine. a) resistance between terminals of the air intake pre-heater relay should be 64.0 ? 96.0 ohms b) illustration of the air intake pre-heater terminal should be revised. c) r
Bulletin:
167-B0504-12
Component:
063000 engine and engine cooling:exhaust system
Summary:
Sb - 05 - 003 this document is to inform dealers and workshops on procedures to activate exhaust brake operation.
Bulletin:
167-B0505-12
Component:
356000 equipment adaptive
Summary:
Sb ? 05 - 007 design change of water pipe for j08e
Bulletin:
167-B0506-12
Component:
060000 engine (pws)
Summary:
Sb ? 05 - 008 this document is to inform the dealers about the addition of the pressure sensor cover and related part for the j08e engine.
Bulletin:
167-B0508-12
Component:
106000 power train:axle assembly
Summary:
Sb - 05 - 005 proper maintenance procedures for grease lubricated front axles
Bulletin:
167-B0601-12
Component:
060000 engine and engine cooling
Summary:
Sb ? 06 - 001 design change of engine oil cooler housing. the casting for the engine oil cooler housing has been revised to include 2 shallow machined grooves on both sides of the engine oil cooler housing. these grooves aid in the retentio
Bulletin:
167-B0602-12
Component:
061320 engine and engine cooling:engine:other fuel types:turbo-charger
Summary:
Sb ? 06 - 002 fuel filter usage. this bulletin provides technical information for proper fuel filter usage as well as an example of damage caused by foreign material allowed to enter the fuel system as a result of using an improper fuel fil
Bulletin:
167-B0803-12
Component:
203000 wheels:lugs/nuts/bolts
Summary:
Sb - 08 - 005 this document is to inform dealers and workshops of the design change to the hood damper, support bolt and the addition of a support collar.
Bulletin:
167-B1415-12
Component:
355200 equipment:other:owners/service/other manual
Summary:
Sb-14-003 the following is to inform you of the revision of the inspection procedure for the dtc?s p0340 and p0341. you are kindly requested to attach this service data to the relevant pages of the workshop manuals for maintenance and to us
Bulletin:
167-B1503-12
Component:
355200 equipment:other:owners/service/other manual
Summary:
Sb-15-002 correction of workshop manual for 2013 - 2015my (revision of troubleshooting procedure for the dtc p2123)
Bulletin:
167-B1504-12
Component:
355200 equipment:other:owners/service/other manual
Summary:
Sb-15-003 correction of workshop manual for hino 2015my (revision of troubleshooting procedure for the dtc p0421)
Bulletin:
167-B1514-12
Component:
100000 power train
Summary:
Sb-15-015 information of troubleshooting procedure for engine lacked power during the dpr automatic regeneration
Bulletin:
167-B1516-12
Component:
063200 engine and engine cooling:exhaust system:manifold/header/muffler/tail pipe
Summary:
Sb-15-017 new parts are available to prevent repeat exhaust manifold stud failures on the j05 engine. this bulletin provides instructions for an exhaust manifold attachment modification at the #1 and #4 cylinder locations. modifications to
Bulletin:
167-B1521-12
Component:
020000 suspension
Summary:
Sb-15-022 in the rare event that a subject vehicle equipped with the 23k comfort ride air suspension experiences a premature main leaf failure, a 23k hd comfort ride air suspension may be installed with prior approval from hmm qa.
Bulletin:
167-B1523-12
Component:
060000 engine and engine cooling
Summary:
Sb-15-026 a subject vehicle may exhibit an engine oil leak or engine coolant leaking externally from the engine head gasket sealing area on the exhaust manifold side of the engine. an improved head gasket has been made available as a servic
Bulletin:
167-T1420-12
Component:
162800 structure:body:hood
Summary:
Tt-14-021 this procedure illustrates a worst case scenario repair procedure, the process and materials being used are the same for all repairs. depending on the location of the repair, access may be limited in some cases. ensure that the re
Bulletin:
167-T1425-12
Component:
117000 digital instrument panel
Summary:
Tt-14-029 a subject vehicle at 200,000 miles may exhibit a "dpr maintenance" message displayed on the instrument cluster message center. the following procedure will instruct how to check the dpf and reset the displayed message.
Bulletin:
167-B1621-12
Component:
355200 equipment:other:owners/service/other manual
Summary:
Sb-16-010 correction of the inspection of the dpr filter.
Bulletin:
167-B1625-12
Component:
355200 equipment:other:owners/service/other manual
Summary:
Sb-16-021 correction of workshop manual for hino600 series correction of electrical wiring diagram
Bulletin:
167-B1101-12
Component:
090000 fuel system, other
Summary:
Sb-11-002 requirements of biofuel usage for 2008my thru 2012my vehicles all applied models
Bulletin:
167-B1307-12
Component:
103300 power train:automatic transmission:gear position indication (prndl)
Summary:
13-008 design change of the idler gear case and idler gear bolt. abnormal load such as a stuck supply pump was applied to gear train then causing the bolt to loosen. therefore, an enhancement to the case and bolt were carried out. the idle
Bulletin:
167-B1312-12
Component:
355200 equipment:other:owners/service/other manual
Summary:
Sb-13-009 this bulletin is to inform dealers and workshops of proper paint codes for all hino models. all models
Bulletin:
167-T0706-12
Component:
355200 equipment:other:owners/service/other manual
Summary:
07 - 006 voltage drop test
Bulletin:
167-T1514-12
Component:
162000 structure:body
Summary:
Tt-15-016 the purpose of this publication is to communicate the standard measuring positions on the hino chassis. in some cases, the customer may report a visual chassis posture concern where the chassis appears to be leaning more towards t
Bulletin:
167-T1612-12
Component:
060000 engine (pws)
Summary:
Tt-16-013 the procedure for installing the rocker shaft bolts into the cam housing has been updated. it is recommended to lightly lubricate the threads and flange of the bolts with clean engine oil before installing them. the torque specifi

Home | Privacy