2008 PREVOST WE TSBs (19)
- Bulletin:
- WB13-64B
- Component:
- 063000 engine and engine cooling:exhaust system
- Summary:
- On the vehicles affected by this bulletin, an inspection of the exhaust gas diffuser is necessary. refer to part 1 of this bulletin for the inspection procedure. if the inspection procedure reveals that the diffuser rain cap is not function
- Bulletin:
- IS-13158
- Component:
- 353000 equipment:electrical
- Summary:
- This instruction sheet explains how to install keyless keypad using either kit 069140 or 069141
- Bulletin:
- IS-14130
- Component:
- 353600 equipment:air conditioner
- Summary:
- This instruction sheet explains how to use retrofit kit for obsoleted small ac condensers (950018 & 950335)
- Bulletin:
- IS-17901
- Component:
- 030000 brakes (pws)
- Summary:
- This instructions sheet explains how to program a wabco smart trac abs ecu.
- Bulletin:
- IS-11003E
- Component:
- 110000 electrical system
- Summary:
- This instruction sheet explains how to remplace master id? with ?mcm? module
- Bulletin:
- MI16-15A
- Component:
- 199000 tires:pressure monitoring and regulating systems
- Summary:
- The beru sensors used on prevost vehicles to monitor tire pressure (tpms system) are being replaced by new huf sensors and their corresponding stainless valves stems. since the older and newer sensors are using different valve stems, repla
- Bulletin:
- MI16-22
- Component:
- 353000 equipment:electrical
- Summary:
- Use this maintenance information procedure to resolve an undesired behaviour on 2008-2012 vehicles. in sleep mode, certain marker lights may remain illuminated.
- Bulletin:
- IS-11003D
- Component:
- 355200 equipment:other:owners/service/other manual
- Summary:
- This instruction sheet explains how to remplace master id? with ?mcm? module
- Bulletin:
- MI16-15B
- Component:
- 351300 equipment:recreational vehicle:lpg tank valve/gauge
- Summary:
- The beru sensors used on prevost vehicles to monitor tire pressure (tpms system) are being replaced by new huf sensors and their corresponding stainless valves stems. since the older and newer sensors are using different valve stems, repla
- Bulletin:
- IS-11003A
- Component:
- 355200 equipment:other:owners/service/other manual
- Summary:
- This instruction sheet explains how to replace master id? with ?mcm? module
- Bulletin:
- WB15-44A
- Component:
- 200000 wheels
- Summary:
- On the vehicles affected by this bulletin, the equipment used to tighten the wheel lugs in a visit to one of our service center between november 2014 and june 2015, was found to be out of specification, possibly delivering a torque value i
- Bulletin:
- Mi16-15
- Component:
- 199000 tires:pressure monitoring and regulating systems
- Summary:
- The beru sensors used on prevost vehicles to monitor tire pressure (tpms system) are being replaced by new huf sensors and their corresponding stainless valves stems. since the older and newer sensors are using different valve stems, repla
- Bulletin:
- SCI17-35
- Component:
- 118000 electrical system: software
- Summary:
- This internal instruction explains how to bench program the fms gateway module used in the eld (electronic logging device) interface kit for pre-obd13 vehicles.
- Bulletin:
- MI15-24
- Component:
- 350000 equipment
- Summary:
- This maintenance information explains how to perform an inspection of the vehicle power cables. power cables in poor condition can be the cause of failures and serious damages in the engine compartment.
- Bulletin:
- MI15-18
- Component:
- 160000 structure
- Summary:
- This maintenance information does explain how five year old vehicles and older should be subjected to a thorough structural inspection.
- Bulletin:
- MI1240
- Component:
- 110000 electrical system
- Summary:
- On the vehicles affected, the delco 50dn alternator may generate a voltage variation when engine is shutting down. a new circuit and a time delay function can be added to the system to provide protection.
- Bulletin:
- SCI12-46A
- Component:
- 060000 engine and engine cooling
- Summary:
- This procedure will guide you through the steps required to relocate the evaporator filters on le mirage xl-ii entertainers. the heating coil in the evaporator compartment should be drained from coolant and some work and assembly is require
- Bulletin:
- MI13-33
- Component:
- 023100 suspension:multiple axle:torque arm
- Summary:
- This maintenance information explains that polyester reinforced silicone hoses and elbowscan be repalced by aramid reinforced hoses and elbows for improved long term durability, and that constant torque hose clamps for silicone hoses with 5
- Bulletin:
- SP13-44
- Component:
- 110000 electrical system
- Summary:
- The light switch may operate incorrectly when doors are closed for vehicles affected by this bulletin. corrective action is presented.
Home | Privacy