2006 BMW F650 GS Recall
- Campaign:
- 07V151000 on 04/04/2007
- Component:
- Structure:motorcycle kickstand/center stand
- Manufactured:
- 06/22/2006 - 08/30/2006
- Affected:
- 305
- Defect:
- On certain motorcycles, the weld between the side stand and the frame bottom section was not positioned properly. the load-bearing capability of the side stand is affected. as a result, the side stand could fail.
- Consequence:
- If this occurred when the motorcycle was parked, the motorcycle could fall to the ground and injure a person sitting on the motorcycle or a person nearby.
- Correction:
- Dealers will install a new frame bottom section free of charge. the recall began on june 1, 2007. owners may contact bmw at 1-800-831-1117.
- Notes:
- Customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.safercar.gov.
2006 BMW F650 GS TSBs (7)
- Bulletin:
- 13-003-08
- Component:
- 011000 steering:wheel and handle bar
- Summary:
- Bmw motorcycle: replacement of fuel-pressure sensor. check of position of protective film (f-800 gs only). *pe
- Bulletin:
- SB-61-003-08
- Component:
- 036500 service brakes, hydraulic:antilock:wheel speed sensor
- Summary:
- Bmw vehicles: routing abs front wheel speed sensor cable. the wiring harness front wheel speed sensor periphery plug connection is mounted on the fork cover at the bottom. *pe
- Bulletin:
- TB-61-002-08
- Component:
- 114000 electrical system:wiring
- Summary:
- Bmw mc: wiring harness of motorcycles is routed along right hand top rail of frame. weld spatter on frame and/or adverse routing in vicinity of banjo bolt of hydraulic spring base adjuster can result in chafing of the wiring harness. m
- Bulletin:
- TSB-17-001-09
- Component:
- 062300 engine and engine cooling:cooling system:hose
- Summary:
- Bmw motorcycle: the coolant inlet hose is not compliant with the applicable bmw specifications. engine operation can cause the inlet hose to widen and become correspondingly shorter; overtime this contraction in length can cause the hose to
- Bulletin:
- SB-00-021-07
- Component:
- 090000 fuel system, other
- Summary:
- Bmw motorcycle: engine fuels containing ethanol. bmw motorrad has no objection to the use of si engine fuels containing up to a maximum of 10% ethanol and imposes no warranty restrictions. ethanol mixtures in proportions higher than 10%
- Bulletin:
- SIB-16-02-09
- Component:
- 072100 fuel system, gasoline:delivery:fuel pump
- Summary:
- Bmw vehicles: fuel level sensor repairs. where it is necessary to replace the right or the left side fuel level sensor due to a failure, the entire pump and housing or delivery unit (suction jet assembly) do not need to be replaced as wel
- Bulletin:
- SIB-63-02-01
- Component:
- 120000 exterior lighting
- Summary:
- Bmw: procedure for determining and replacing incandescent and halogen light bulbs under warranty. *rm
Home | Privacy