2005 BMW HP2 ENDURO Recall

Campaign:: 08V564000 on 10/22/2008
Component:: Suspension
Manufactured:: 08/15/2004 - 08/02/2006
Affected:: 365
Defect:: Bmw is recalling 365 my 2005-2006 hp2 enduro motorcycles. the front threaded fastener of the paralever link may not have been tightened to correct specifications. if the fastener was not tightened according to specifications, it could loosen. over time, it is possible for the fastener to separate from its housing. if this were to occur, then the final drive of the motorcycle would not be properly supported.
Consequence:: If that happened, motorcycle handling would be compromised increasing the risk of a crash.
Correction:: Dealers will remove the front threaded fastener of the paralever link and replace it with an improved fastener. the recall began on january 7, 2009. owners may contact bmw at 1-800-831-1117.
Notes:: Customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.safercar.gov.

2005 BMW HP2 ENDURO TSBs (4)

Bulletin:: SB-00-021-07
Component:: 090000 fuel system, other
Summary:: Bmw motorcycle: engine fuels containing ethanol. bmw motorrad has no objection to the use of si engine fuels containing up to a maximum of 10% ethanol and imposes no warranty restrictions. ethanol mixtures in proportions higher than 10%
Bulletin:: SIB-16-02-09
Component:: 072100 fuel system, gasoline:delivery:fuel pump
Summary:: Bmw vehicles: fuel level sensor repairs. where it is necessary to replace the right or the left side fuel level sensor due to a failure, the entire pump and housing or delivery unit (suction jet assembly) do not need to be replaced as wel
Bulletin:: SIB-63-02-01
Component:: 120000 exterior lighting
Summary:: Bmw: procedure for determining and replacing incandescent and halogen light bulbs under warranty. *rm
Bulletin:: MC64010520
Component:: 117000 digital instrument panel
Summary:: Incorrect tire pressure appears in the instrument cluster. contamination or obstruction of the rdc sensor.