1998 BMW K1200RS Recalls (4)
- Campaign:
- 97V134000 on 08/28/1997
- Component:
- Service brakes, hydraulic
- Manufactured:
- 02/28/1997 - 08/29/1997
- Affected:
- 973
- Defect:
- Vehicle description: motorcycles. the adjusting screw for the pressure point of either the brake or clutch levers may not be sufficiently tight, due to grease contamination of the threads.
- Consequence:
- The screw(s) can back out over time while the vehicle is being operated causing a change in the pressure point of the master cylinder for the clutch and/or front brake increasing the risk of a vehicle crash.
- Correction:
- Dealers will check the adjustment screws of the front brake and clutch levers for movement. if the screws are tight, no further action will be taken. if a screw is found to be loose, it will be removed, cleaned and reinstalled with new loctite.
- Notes:
- Owner notification began august 11, 1997.owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact bmw at 1-800-831-1117, option #5.also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
- Campaign:
- 98V258000 on 10/14/1998
- Component:
- Fuel system, gasoline:storage:tank assembly
- Manufactured:
- 12/31/1996 - 10/30/1997
- Affected:
- 1,000
- Defect:
- Vehicle description: motorcycles. during extended operation in high ambient temperature conditions, the area of the pump mounting surface of the fuel tank can deform, forming a gap between the tank mounting surface and the gasket, allowing fuel to escape from the tank at that area.
- Consequence:
- If an ignition source was present, a fire could occur resulting in personal injury.
- Correction:
- Dealers will replace the fuel pump-to-tank gasket.
- Notes:
- Owner notification is expected to begin by the end of december 1998.owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact bmw at 1-800-831-1117.also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).
- Campaign:
- 00V264000 on 09/13/2000
- Component:
- Engine and engine cooling:engine
- Manufactured:
- 01/31/1997 - 08/30/1999
- Affected:
- 2,368
- Defect:
- Vehicle description: motorcycles. a spring-loaded thermostatic element in the oil thermostat housing is held in place by a cover that is retained by a snap ring. the snap ring may not have been properly installed during production. during vehicle operation, the snap ring could unseat, allowing the cover to loosen or detach, resulting in loss of the entire oil volume.
- Consequence:
- Engine damage could occur if the engine is not immediately switched off. in addition, oil could travel along the engine cover and ultimately contact the rear tire, reducing its traction and affecting the stability of the motorcycle, possibly resulting in a crash and personal injury.
- Correction:
- Dealers will inspect the snap ring installation and if the snap ring is not fully seated, the complete oil pump intermediate flange will be replaced.
- Notes:
- Owner notification began october 13, 2000. owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact bmw at 1-800-831-1117, option #5. also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).
- Campaign:
- 00V266000 on 09/13/2000
- Component:
- Engine and engine cooling:engine
- Manufactured:
- 03/19/1997 - 04/13/1997
- Affected:
- 188
- Defect:
- Vehicle description: motorcycles. the cylinder head contains two sealing plugs covering holes in the area near the spark plugs. one or both plugs may not have been fully seated during vehicle assembly. either or both of the sealing plugs could loosen or completely detach from their mounting point during vehicle operation.
- Consequence:
- This condition could allow coolant to escape, travel along the engine cover, and contact the rear tire, reducing its traction and affecting the stability of the motorcycle. in addition, the loss of coolant could lead to increased engine operating temperature and possible overheating.
- Correction:
- Dealers will replace the sealing plugs with a stainless steel plug design.
- Notes:
- Owner notification began october 12, 2000.owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact bmw at 1-800-831-1117, option #5. also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).
1998 BMW K1200RS TSBs (3)
- Bulletin:
- 281898
- Component:
- 101000 power train:clutch assembly
- Summary:
- Information on new clutch parts. *yc
- Bulletin:
- SB-00-021-07
- Component:
- 090000 fuel system, other
- Summary:
- Bmw motorcycle: engine fuels containing ethanol. bmw motorrad has no objection to the use of si engine fuels containing up to a maximum of 10% ethanol and imposes no warranty restrictions. ethanol mixtures in proportions higher than 10%
- Bulletin:
- MC62133778
- Component:
- 350000 equipment
- Summary:
- Map data should be stored on a 64 gb sd card. in garmin express the note appears that a maximum of 32 gb is possible.
Home | Privacy