1997 INTERNATIONAL HARVESTER 8100 Recalls (3)
- Campaign:
- 96V240000 on 11/26/1996
- Component:
- Suspension:rear
- Manufactured:
- 09/02/1996 - 10/01/1996
- Affected:
- 233
- Defect:
- Vehicle description: school buses and heavy duty trucks equipped with rear axle assemblies produced by dana spicer. certain rear axle assemblies were improperly heat treated which could allow pinion breakage at the pinion threads.
- Consequence:
- Cracks can initiate and result in separation of the threaded end of the pinion resulting in separation of the yoke and drive line from the rear axle increasing the risk of a vehicle accident.
- Correction:
- Dealers will replace the rear axle carrier/pinion assembly.
- Notes:
- Owner notification:owner notification will begin december 20, 1996. note:owners who take their buses to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact navistar at 1-800-448-7825.also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
- Campaign:
- 96V233002 on 12/18/1996
- Component:
- Suspension:rear
- Manufactured:
- 04/15/1996 - 10/15/1996
- Affected:
- 1,133
- Defect:
- The drive axle housings consist of a plate steel center section and two forged spindles, one of which is welded to each end of the center section. each spindle contains a keyway slot in which the locking tab for the wheel bearing nut locking mechanism is inserted. the length of the keyway slot may not be long enough to accommodate the tab causing the tab to be deformed or damaged during installation.
- Consequence:
- This locking tab prevents the wheel bearing nut from loosening during vehicle operation. if this tab is deformed, the nut can loosen allowing the wheel to separate from the axle increasing the risk of a vehicle accident.
- Correction:
- Dealers will replace the drive axle housing nuts with a conventional wheel nut hardware system.
- Notes:
- Owner notification:owner notification began december 10, 1996. note: owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact navistar at 1-800-448-7825.also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
- Campaign:
- 01V023000 on 02/06/2001
- Component:
- Service brakes, air:slack adjusters
- Manufactured:
- 10/06/1996 - 11/13/2000
- Affected:
- 2,855
- Defect:
- Vehicle description: heavy duty trucks equipped with air brake haldex automatic slack adjusters, long stroke brake chambers, and dana brakes. the automatic slack adjuster anchor brackets can fail due to fatigue fracture and completely separate, causing the slack adjusters to function as manual slack adjusters.
- Consequence:
- If the support bracket for an automatic slack adjuster fails, the brakes at that wheel end will not automatically adjust. as the brake linings wear, the vehicle will have reduced braking capacity, increasing the risk of a crash.
- Correction:
- Dealers will install a new bracket on each suspect slack adjuster. owner notification began february 22, 2001. owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact international at 1-800-448-7825.
- Notes:
- Also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).
1997 INTERNATIONAL HARVESTER 8100 TSB
- Bulletin:
- IK-0400107
- Component:
- 030000 brakes (pws)
- Summary:
- International: after lining condition and wear, fastener torque, component lubrication have been verified on the brakes because of the chatter or squealing on the trucks, a procedure will be performed. no model or model years are liste
Home | Privacy