1996 INTERNATIONAL HARVESTER 9300 Recalls (5)
- Campaign:
- 95V174000 on 09/11/1995
- Component:
- Power train:driveline
- Manufactured:
- 06/30/1995 - 07/31/1995
- Affected:
- 651
- Defect:
- The driveline could have little torque or no torque on the driveline nut that retains the yoke at the center bearing or bearings if the vehicle is equipped with multiple center bearings.
- Consequence:
- The low torque condition can cause the driveline to separate resulting in personal injury or property damage from parts being thrown from the vehicle or scattered on the roadway.
- Correction:
- Dealers will disconnect the driveline at the rear of the center bearing(s), torque the yoke nut and reconnect the driveline.
- Notes:
- System: powertrain; driveline.vehicle description: heavy duty trucks.note: owners who take their vehicle to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact navistar at 1-800-448-7825. also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
- Campaign:
- 95V182000 on 09/25/1995
- Component:
- Equipment:recreational vehicle
- Manufactured:
- 10/31/1994 - 08/31/1995
- Affected:
- 1,843
- Defect:
- Straps holding the sleeper upper bunk in the raised position can release without warning.
- Consequence:
- If the restraining strap releases suddenly, the bunkfalls without warning and can strike an occupant sitting in the lower bunk causing personal injury.
- Correction:
- Dealers will modify the attachment of the upper bunk restraining strap to the upper bunk and rear wall of the sleeper and install a new redesigned bunk restraining strap.
- Notes:
- System: equipment; bunk sleeper. vehicle description: trucks equipped with double sleeper bunks.note: owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact navistar international at 1-800-448-7825. also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
- Campaign:
- 96V124004 on 10/21/1996
- Component:
- Suspension
- Manufactured:
- 07/30/1995 - 03/13/1996
- Affected:
- 21
- Defect:
- The equalizing beam shaft of the tandem axle suspension were manufactured from as-rolled sae4140 steel rather than the specified annealed sae4140. these shafts can fracture inside the beam at the toe of the weld.
- Consequence:
- Vehicles are subject to vehicle tilt and possible rollover in the event that both equalizing beams, on the same side of the vehicle, experience a simultaneous shaft failure. affected suspensions can also drop and contact the road surface generating sparks which could ignite flammable material.
- Correction:
- Owner notification is being conducted by neway anchorlok. dealers will inspect and replace all suspension suspension beams with suspension beams containing appropriate shafts.
- Notes:
- Owner notification:owner notification is being conducted by neway anchorlok and began july 18, 1996.note:owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact neway at 1-800-237-8932.also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
- Campaign:
- 01V023000 on 02/06/2001
- Component:
- Service brakes, air:slack adjusters
- Manufactured:
- 10/06/1996 - 11/13/2000
- Affected:
- 2,855
- Defect:
- Vehicle description: heavy duty trucks equipped with air brake haldex automatic slack adjusters, long stroke brake chambers, and dana brakes. the automatic slack adjuster anchor brackets can fail due to fatigue fracture and completely separate, causing the slack adjusters to function as manual slack adjusters.
- Consequence:
- If the support bracket for an automatic slack adjuster fails, the brakes at that wheel end will not automatically adjust. as the brake linings wear, the vehicle will have reduced braking capacity, increasing the risk of a crash.
- Correction:
- Dealers will install a new bracket on each suspect slack adjuster. owner notification began february 22, 2001. owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact international at 1-800-448-7825.
- Notes:
- Also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).
- Campaign:
- 04V100000 on 03/03/2004
- Component:
- Equipment:recreational vehicle
- Manufactured:
- 03/31/1994 - 06/15/2002
- Affected:
- 83,312
- Defect:
- On certain conventional trucks equipped with pro-sleeper berths, water intrusion can be found in the bunk control panel area and pool in the tops of the dome light, tv/vcr, and or refrigerator power switches.
- Consequence:
- The circuit boards in the switches could heat up , possibly produce a flame or fire, and cause property damage, personal injury, or death.
- Correction:
- Dealers will install a water shield over the back of the entire bunk control panel. owner notification began on july 16, 2004. owners should contact international at 1-800-448-7825.
- Notes:
- International recall no. 04503.customers can contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).
1996 INTERNATIONAL HARVESTER 9300 TSB
- Bulletin:
- 970601G97902
- Component:
- 062200 engine and engine cooling:cooling system:fan
- Summary:
- Conditions regarding fan belt misalignment. *yc
Home | Privacy