1996 INTERNATIONAL HARVESTER 5000 Recall

Campaign:

96V124004 on 10/21/1996

Component:

Suspension

Manufactured:

07/30/1995 - 03/13/1996

Affected:

21

Defect:

The equalizing beam shaft of the tandem axle suspension were manufactured from as-rolled sae4140 steel rather than the specified annealed sae4140. these shafts can fracture inside the beam at the toe of the weld.

Consequence:

Vehicles are subject to vehicle tilt and possible rollover in the event that both equalizing beams, on the same side of the vehicle, experience a simultaneous shaft failure. affected suspensions can also drop and contact the road surface generating sparks which could ignite flammable material.

Correction:

Owner notification is being conducted by neway anchorlok. dealers will inspect and replace all suspension suspension beams with suspension beams containing appropriate shafts.

Notes:

Owner notification:owner notification is being conducted by neway anchorlok and began july 18, 1996.note:owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact neway at 1-800-237-8932.also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

1996 INTERNATIONAL HARVESTER 5000 TSB

Bulletin:

971001G96906

Component:

102000 power train:manual transmission

Summary:

Installation of aeroquip snap to connect (stc) fitting locking clips. *yc

Home | Privacy