1996 BMW R850 Recall

Campaign:

97V237000 on 01/04/1998

Component:

Electrical system:wiring

Manufactured:

09/30/1994 - 08/29/1996

Affected:

2,000

Defect:

Vehicle description: motorcycles. a sheet metal plate mounted to the front of the frame below the instrument cluster can cause the wiring harness to be stretched too tight as the handlebars are turned fully to one side. in addition, the wiring harness is attached to another harness with a cable tie that is placed too far forward limiting the handlebar movement.

Consequence:

The harness wires can be damaged or could break or pull out of the ignition switch. if the harness wires were damaged but not broken or disconnected, the electrical system could be affected while the motorcycle is being driven. hesitation, misfiring, or "cutting out" could occur increasing the risk of a vehicle crash.

Correction:

Dealers will relocate the wire tie connecting the two wiring harnesses to a point further back from the original location so that the ignition switch wiring harness has sufficient freedom of movement. also if the wiring harness is found to be damaged, the ignition switch (with harness) will be replaced.

Notes:

Owner notification is expected to begin by late february 1998.owners who take their motorcycles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact bmw at 1-800-831-1117, option #5.also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

1996 BMW R850 TSB

Bulletin:

SB-00-021-07

Component:

090000 fuel system, other

Summary:

Bmw motorcycle: engine fuels containing ethanol. bmw motorrad has no objection to the use of si engine fuels containing up to a maximum of 10% ethanol and imposes no warranty restrictions. ethanol mixtures in proportions higher than 10%

Home | Privacy