1995 INTERNATIONAL HARVESTER 4700 Recalls (5)

Campaign:
94V144000 on 08/16/1994
Component:
Engine and engine cooling:engine:gasoline:turbo-charger
Manufactured:
12/31/1993 - 02/28/1994
Affected:
373
Defect:
Four compression backplate retaining fasteners on the turbo-charger were torqued only hand tight. this allows the fasteners to loosen, and causes oil to leak into the compressor air side of the turbo-charger which, when coupled with the heat precipitated by the compressor and the mixing action of the compressor wheel, can result in an air/oil mixture that fuels the engine.
Consequence:
When this occurs, engine run-on and subsequent loss of operator control via the normal throttle mechanism can occur, which could result in a vehicle accident.
Correction:
Replace the suspect turbo-charger with a new turbo-charger.
Notes:
System: engine; turbo-charger.vehicle description: trucks and buses equipped with navistar i-6 engines.note: if your vehicle is presented to an authorized dealer on an agreed upon service date and the remedy is not provided within a reasonable time free of charge or the remedy does not correct the defect, please contact navistar at 1-800-448-7825. also, contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
Campaign:
94V196000 on 10/27/1994
Component:
Vehicle speed control:accelerator pedal
Manufactured:
12/31/1993 - 05/31/1994
Affected:
6,449
Defect:
The base of the electronic accelerator pedal is made of die cast aluminum. the base mounts directly to the cab firewall. the cab firewall is not rigid enough or flat enough at the mounting surface, causing stress on the accelerator base that will cause the mounting pads on the base of the pedal assembly to fail and totally separate from the firewall.
Consequence:
This can cause loss of speed control, driver distraction, and result in an accident.
Correction:
Dealers will inspect the accelerator pedal assembly and install a plate between the accelerator mounting base and the firewall on those units where the base is not broken and has no visible signs of a crack. if the base is broken or cracked, the accelerator assembly will be replaced with a new redesigned accelerator pedal assembly.
Notes:
System: fuel; throttle linkages and control; pedal.vehicle description: transit buses, school buses, heavy and medium duty trucks.note: if the vehicle is presented to an authorized dealer on an agreed upon service date and the remedy is not provided free of charge within a reasonable time or the remedy does not correct the defect, please contact navistar at 1-800-448-7825. also, contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
Campaign:
94V232000 on 11/30/1994
Component:
Parking brake:driveline:hydraulic:hoses, lines/piping, and fittings
Manufactured:
02/28/1994 - 08/31/1994
Affected:
71
Defect:
At low ambient temperature, with the parking brake applied abd the engine running, pressure can build up sufficiently to partially pressurize the brake chamber which controls the ddm park brake at the rear of the transmission allowing the parking brake to partially release.
Consequence:
If the vehicle is parked on a moderate incline, the vehicle can roll away without warning and possibly result in an accident.
Correction:
Dealers will re-plumb the hydraulic lines of the hydraulic park brake system preventing unintentional release of the park brake.
Notes:
System: emergency parking brake; air; check valve.vehicle description: medium duty trucks built with hydraulic actuated ddm parking brakes.note: if the vehicle is presented to an authorized dealer on an agreed upon service date and the remedy is not provided free of charge within a reasonable time or the remedy does not correct the defect, please contact navistar at 1-800-448-7825. also, contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
Campaign:
00V413000 on 12/11/2000
Component:
Service brakes, air:slack adjusters
Manufactured:
01/05/1995 - 04/27/1995
Affected:
40
Defect:
Vehicle description: heavy duty trucks. the vehicles involved in this recall were built for export with manual slack adjusters and were sold in the us. these vehicles need to have automatic slack adjusters in order to comply with the requirements of fmvss 121, "air brake systems."
Consequence:
These vehicles do not comply with the standards.
Correction:
Dealers will replace the manual slack adjusters will automatic slack adjusters.
Notes:
Owner notification is expected to begin during december 2000.owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact international at 1-800-448-7825.also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).
Campaign:
03V083000 on 03/16/2003
Component:
Seats
Manufactured:
12/12/1994 - 09/03/1998
Affected:
2,418
Defect:
On certain heavy duty trucks equipped with bostrom driver seat models 910, 910sc, or 914 and international's parking brake code 04036, if someone outside the cab adjusts/slides the driver's seat to its most forward position, with the parking brake set, the seat will contact and release the parking brake lever.
Consequence:
If the parking brake is accidentally released, the vehicle could move unexpectedly, increasing the risk of a crash.
Correction:
dealers will install a stop-bracket on the seat track to limit the travel of the seat so that the seat cannot release the parking brake lever. owner notification began on march 31, 2003. owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact international at 1-800-448-7825.
Notes:
International recall no. 03503.(previously 01503)customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

1995 INTERNATIONAL HARVESTER 4700 TSB

Bulletin:
IK-0400107
Component:
030000 brakes (pws)
Summary:
International: after lining condition and wear, fastener torque, component lubrication have been verified on the brakes because of the chatter or squealing on the trucks, a procedure will be performed. no model or model years are liste

Home | Privacy