1993 FORD F700 Recalls (4)

Campaign:
92V164000 on 11/26/1992
Component:
Wheels
Manufactured:
08/31/1992 - 08/31/1992
Affected:
192
Consequence:
Using the wrong sized clamps to attach the rim and tireassembly to the wheel spokes could cause the studs that attach the clamps to thespokes to bend. if the studs are bent, there is an increased risk of studfracture that could result in the rim and tire assembly breaking from thewheel.
Correction:
Replace the clamps and studs on the cast spoke wheels.
Notes:
System: wheels.vehicle description: incomplete 6000 to 12000 pound front gawr chassis-cabvehicles equipped with cast spoke wheels.decription of defect: one or more of the six clamps that hold the tire and rimassembly to the cast spokes of the front wheel may have been of an incorrectsize.note: the f150, f250, f350, f-super duty, and the bronco vehicles are notinvolved in this recall campaign.
Campaign:
93V160000 on 09/28/1993
Component:
Vehicle speed control:springs
Manufactured:
02/29/1992 - 04/30/1993
Affected:
20,000
Defect:
As a result of inherent vibration in these engines, the throttle return springs can fracture.
Consequence:
If one of the two return springs fractures while thevehicle is being driven, a substantial reduction in accelerator pedal effortwould be felt. if the second spring also fractures, the throttle would notreturn to idle position and can result in increased engine speed and thepossibility of loss of vehicle control and an accident.
Correction:
The throttle return control system with the coil torsion spring design will be replaced.
Notes:
System: fuel: throttle linkages and control return spring.vehicle description: medium and heavy trucks, truck chassis, and bus chassisequipped with cummins 5.9l and 8.3l diesel engines with in-line fuel injectionpumps.note: if your vehicle is presented to an authorized dealer on an agreed uponservice date and the remedy is not provided within a reasonable time and freeof charge or the remedy is does not correct the defect or noncompliance, pleasecontact the ford service center at 1-800-392-3673. also, contact the nationalhighway traffic safety administration's auto safety hotline at 1-800-424-9393.
Campaign:
95V143000 on 08/09/1995
Component:
Vehicle speed control
Manufactured:
02/28/1993 - 07/31/1994
Affected:
29,000
Defect:
The hand throttle cable can wear the brass swivel block on the governor lever through which it passes.
Consequence:
This wear can result in the governor jamming in thedamaged swivel and could prevent the governor lever from returning to the idle position.
Correction:
Dealers will install a revised governor lever with a stainless steel swivel. also letters will be sent to vehicle owners that have the same vehicles but do not have a ford installed hand throttle advising them that they may require service if they have had an after market hand throttle installed.
Notes:
System: fuel; throttle linkages and control.vehicle description: trucks, chassis-cabs and cowl-chassis vehicles with inline fuel injection pump equipped fd-1060 or fd-1460 engines and hand throttles.note: the vehicle brakes are capable of overriding the engine power and bringing the vehicle to a stop.note: owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonablet ime, should contact ford at 1-800-392-3673. also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
Campaign:
95E003008 on 09/26/1995
Component:
Service brakes, air:supply:hoses, lines/piping, and fittings
Manufactured:
01/31/1993 - 02/28/1994
Affected:
3,500
Defect:
Air system blockage in the air dryer occurs degrading the moisture removing capabilities of the dryer when the vehicle is operated in a cold environment and moisture accumulates and freezes in the air dryer or in the line between the dryer and the air system reservoir. the air dryer can become overpressurized causing the air dryer cartridge to separate from the mounting base.
Consequence:
If the air dryer separates from the base, the cartridge can separate sufficiently enough to cause personal injury or property damage.
Correction:
Dealers will equip air systems with a pressure relief valve to be located between the compressor and the air dryer. this pressure relief valve is intended to vent if excessive pressure develops in the air dryer.
Notes:
System: brakes; air dryer.vehicle description: trucks and chassis-cab vehicles equipped with air brakes and rockwell wabco system saver "1000" air dryer.note: if your vehicle is presented to an authorized dealer on an agreed upon service date and the remedy is not provided free of charge within a reasonable time, contact rockwell wabco at 1-800-535-5560 or ford at 1-800-392-3673. also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

1993 FORD F700 TSBs (9)

Bulletin:
95724
Component:
075000 fuel system, gasoline:carburetor system
Summary:
new service kit for retaining the diesel engine plastic air cleaner. *tw
Bulletin:
9582
Component:
061100 engine and engine cooling:engine:gasoline
Summary:
a revised service windshield wiper motor is now available. *tw
Bulletin:
951115
Component:
114000 electrical system:wiring
Summary:
stall or no start - fuel shutdown solenoid - wiring chafing on fuel injector lines-vehicles built before 10/19/94 with fd1060 engine and bosch p7100 fuel injection pump. *tw
Bulletin:
951515
Component:
013000 steering:gear box (other than rack and pinion)
Summary:
steering gear-replacement of bendix, steering gear with new ross steeering gear. *sd
Bulletin:
951713
Component:
112000 electrical system:alternator/generator/regulator
Summary:
generator-motorcraft 95amp-front bearing concern-fd1060/1460 engines- vehicles built before 7/3/95. *sd
Bulletin:
951714
Component:
061100 engine and engine cooling:engine:gasoline
Summary:
engine- 'knocking' noise - when operating engine at 200-2300 rpm - fd1460 engine
Bulletin:
962213
Component:
063200 engine and engine cooling:exhaust system:manifold/header/muffler/tail pipe
Summary:
Exhaust - exhaust leak at exhaust manifolds - vehicles equipped with 7.0l or 7.5l engine. *tw
Bulletin:
98156
Component:
063200 engine and engine cooling:exhaust system:manifold/header/muffler/tail pipe
Summary:
Exhaust leak at exhaust manifolds--vehicle equipped with 7.0l 0r 7.5l engine. *ak
Bulletin:
01127
Component:
061100 engine and engine cooling:engine:gasoline
Summary:
Some vehicles equipped with 26 inch diameter fans may exhibit an engine overheat condition. *tt

Home | Privacy