1992 OLDSMOBILE CUTLASS Recalls (4)
- Campaign:
- 91V214000 on 12/15/1991
- Component:
- Power train:automatic transmission
- Manufactured:
- 09/30/1991 - 10/31/1991
- Affected:
- 10,141
- Defect:
- The reverse servo apply pin may bind in the case which could cause reverse band distress (loss or slipping of reverse), reverse band drag in drive range (poor performance -- poor power), or the transmission to remain in reverse while the shift indicator shows neutral gear position.
- Consequence:
- If the transmission remains in reverse while the shiftindicator shows neutral, the vehicle may unexpectedly move rearward and resultin a vehicle accident.
- Correction:
- Replace the transaxle where required.
- Notes:
- System: transmission and transmission shift indicator.vehicle description: 1992 "a" and "w" body passenger cars with 4-speedautomatic transmissions.
- Campaign:
- 92V066000 on 05/19/1992
- Component:
- Electrical system:wiring
- Manufactured:
- 02/29/1992 - 02/29/1992
- Affected:
- 33
- Defect:
- The optional remote entry module may have a fault which causes random actuation of interior lamps, door locks, and/or tailgate release. this actuation may occur while the vehicle is in use or unattended.
- Consequence:
- If the tailgate release actuates, the tailgate will open.unrestrained passengers in the rear seat area could fall out of the vehiclewhile the car is in motion, and receive serious injuries.
- Correction:
- Replace the remote entry module with a newly revised module to prevent random actuation.
- Notes:
- System: electrical; remote entry modules.vehicle description: passenger cars (station wagons) with remote entry modules.
- Campaign:
- 95V173000 on 09/11/1995
- Component:
- Seat belts:front:anchorage
- Manufactured:
- 07/31/1988 - 08/29/1995
- Affected:
- 2,216,325
- Defect:
- These vehicles were assembled with rear outboard safety belt anchorages that may not withstand the required load. this does not comply with fmvss no.210, "seat belt assembly anchorages."
- Consequence:
- Consequence of non-compliance: in a collison, stress can cause the attachment metal to tear and allow the anchorage to separate from the body of the vehicle. the safety belt may not protect an occupant in the event of a vehicle crash.
- Correction:
- Dealers will replace the existing anchor bolts with a new shoulder bolt and thread locking adhesive. additionally, noise control patches will be applied at each anchorage.
- Notes:
- System: interior; active restraints; belt anchor and attachment; fmvss no.210.vehicle description: passenger vehicles.note: owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact buick at 1-800-521-7300; chevrolet at 1-800-222-1020; pontiac at 1-800-762-2737; or oldsmobile at 1-800-442-6537. also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.
- Campaign:
- 07E021000 on 03/11/2007
- Component:
- Fuel system, other:storage:tank assembly:pressure relief devices
- Affected:
- 742
- Defect:
- Certain delphi fuel pressure regulators, p/nos. fp10020-11b1, fp10026-11b1, and fp10027-11b1, sold after january 9, 2007, as aftermarket equipment for various passenger vehicles listed above. the universal pressure regulators (upr) were produced without an o'ring and retainer.
- Consequence:
- Fuel may leak, possibly resulting in a fire.
- Correction:
- Delphi will notify owners and replace the upr free of charge. the recall began on april 23, 2007. owners can contact delphi at 877-411-8770.
- Notes:
- This recall only pertains to aftermarket delphi fuel pressure regulators and has no relation to any original equipment installed by general motors.customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.safercar.gov.
1992 OLDSMOBILE CUTLASS TSBs (14)
- Bulletin:
- 435012
- Component:
- 036400 service brakes, hydraulic:antilock:abs warning light
- Summary:
- abs wire harness for the right front wheel may rub on the brake line causing the abs warning light to come on. *tw
- Bulletin:
- 435012A
- Component:
- 036400 service brakes, hydraulic:antilock:abs warning light
- Summary:
- abs warning light is on. *tw
- Bulletin:
- 133405
- Component:
- 021400 suspension:front:macpherson strut
- Summary:
- rear strut related thumping/squeaking noise. *tw
- Bulletin:
- 577106
- Component:
- 103000 power train:automatic transmission
- Summary:
- cold start rattle noise. *tw
- Bulletin:
- 431041A
- Component:
- 162000 structure:body
- Summary:
- Unknown
- Bulletin:
- 9573T4001
- Component:
- 105000 power train:driveline
- Summary:
- grinding and/or growling noise in park on incline.*sd
- Bulletin:
- 577106A
- Component:
- 103000 power train:automatic transmission
- Summary:
- Cold start rattle noise. *tw
- Bulletin:
- 577106A
- Component:
- 105300 power train:driveline:driveshaft
- Summary:
- Cold start rattle noise (diagnosis/service procedure). *tw
- Bulletin:
- 970801735026
- Component:
- 036000 service brakes, hydraulic:antilock
- Summary:
- Comment that the abs light is on with diagnostic trouble codes (dtc's) 46 and 86 set as current or history. *yc
- Bulletin:
- 676001
- Component:
- 063130 engine and engine cooling:exhaust system:emission control:gas recirculation valve (egr valve)
- Summary:
- Excessive oil consumption (replace pcv harness). *tw
- Bulletin:
- 990309004
- Component:
- 020000 suspension
- Summary:
- Customers may complain of grinding / scraping / groaning noise from rear suspension. *tt
- Bulletin:
- 990730030
- Component:
- 106000 power train:axle assembly
- Summary:
- Some vehicles equipped with hydra-matic 3t40, 4t60 or 4t60-e transxales may comment on a grinding and / or growling noise that is noticeable when in park on incline. *tt
- Bulletin:
- 876002A
- Component:
- 061100 engine and engine cooling:engine:gasoline
- Summary:
- Some v6 engines may, on a very infrequent basis, have an oil odor condition that is generally encountered after the engine's oil has been changed.typically the odor lasts approximately 1000 miles after the change of oil and then does not re
- Bulletin:
- 990730030A
- Component:
- 106000 power train:axle assembly
- Summary:
- Owners of some vehicles equipped with hydra-matic 3t40, 4t60, 4t60-e or 4t65-e transaxles may comment on a grinding and / or growling noise that is noticeable when standing in park on a hill or slope with the engine running and the parking
Home | Privacy