1983 FREIGHTLINER CONVENTIONAL Recalls (4)
- Campaign:
- 83V089000 on 10/11/1983
- Component:
- Steering:wheel and handle bar
- Manufactured:
- 03/31/1982 - 03/31/1983
- Affected:
- 328
- Defect:
- The pinch bolt installed on the steering gear component is of a smaller size than specified.
- Correction:
- Dealer will replace the incorrectly sized pinch bolt with a properly sized one if necessary.
- Notes:
- Vehicle description: heavy trucks.system: steering; pinch bolt.consequences of defect: the universal joint drive yoke could slide off thegear, causing loss of steering control and, possibly, an accident.
- Campaign:
- 86V118000 on 08/26/1986
- Component:
- Structure:body
- Manufactured:
- 08/31/1983 - 06/30/1986
- Affected:
- 6,800
- Defect:
- The handhold mounting system, which consists of a tubular handle held in three places by cast aluminum brackets and attached to the engine exhaust muffler heat shield. vibration from this system causes the handhold parts to wear. consequence of defect: if the parts wear thin the possibility exists that the handhold might give way under the weight of a driver. this could result in personal injury.
- Correction:
- Replace the end brackets with a modified design utilizing a rubber isolater. also, add a plastic sleeve to the center bracket for isolation.
- Notes:
- System: structure/handhold. vehicle description: high coe and long convential tractors equipped withvertical bar handhold.
- Campaign:
- 86V137000 on 10/20/1986
- Component:
- Seat belts:front:retractor
- Manufactured:
- 09/30/1983 - 02/28/1986
- Affected:
- 102
- Defect:
- Seat belts can loosen as the truck is driven. consequence of defect: driver and passenger would not be properly restrained in event of a sudden stop or crash.
- Correction:
- Replace the non locking retractor seat belts with automatic locking retractor seat belts.
- Notes:
- System: seat belts. vehicle description: long conventional tractors equipped with non locking retractor seat belts.
- Campaign:
- 88V138000 on 08/21/1988
- Component:
- Equipment:air conditioner
- Manufactured:
- 08/31/1981 - 10/31/1983
- Affected:
- 19,898
- Defect:
- The heater/air conditioner blower motor speed control resistors can under certain conditions overheat and stall.
- Consequence:
- This could result in low air flow across the resistornetwork and high amperage, allowing the air duct to reach elevated temperatureswith the possibility of a fire.
- Correction:
- Install a thermo cutoff device in the heater/air conditioner system and/or replace the blower motor switch.
- Notes:
- System: heater/air conditioner blower motor.vehicle description: long conventional and high cab over engine trucks.
Home | Privacy