1982 CHEVROLET CITATION Recalls (3)
- Campaign:
- 82V018000 on 03/11/1982
- Component:
- Power train:clutch assembly:pedal/linkage
- Manufactured:
- 08/31/1981 - 11/30/1981
- Affected:
- 4,987
- Defect:
- The clutch cable may rub against the master cylinder brake pipe when the clutch pedal is operated. continued operation of the vehicle may result in wear through of the insulation on the clutch cable. the resulting metal on metal contact could lead to failure of the brake pipe, loss of brake fluid, and partial loss of brake action.
- Correction:
- Dealer will inspect and, if necessary, correct system by providing a minimum 1/2 inch clearance between clutch cable and brake pipe to avoid metal on metal contact.
- Notes:
- Vehicle description: passenger vehicles equipped with four speed manualtransmission and power brakes.system: power train; clutch assembly linkage, flexible.consequences of defect: partial loss of brake action could lead to loss ofvehicle control and an accident.
- Campaign:
- 82V021000 on 03/11/1982
- Component:
- Fuel system, gasoline:storage:tank assembly:filler pipe and cap
- Manufactured:
- 01/31/1981 - 12/31/1981
- Affected:
- 519,329
- Defect:
- Under certaain conditions, the hose clamps on the fuel tank filler pipe and fuel tank filler vent pipe could fracture. the fracture of these clamps could cause fuel leakage at any of the four pipe to hose connections. leakage can occur during refueling, or while driving, if the fuel tank is above 3/4 full.
- Correction:
- Dealer will inspect and replace the hose clamps on the fuel tank filler pipe and vent pipe at no cost to owner.
- Notes:
- Vehicle description: passenger vehicles.system: fuel; fuel tank, filler and vent pipes.consequences of defect: if an ignition source is present when fuel leakageoccurs, a fire could start and cause vehicle damage and serious personalinjury.note: until the vehicle can be inspected and the necessary modifications aremade, the fuel tank should not be filled more than 3/4 full. also, the dealershould be contacted immediately if any fuel leakage is detected.
- Campaign:
- 83V007000 on 02/03/1983
- Component:
- Service brakes, hydraulic:foundation components:hoses, lines/piping, and fittings
- Manufactured:
- 04/30/1982 - 05/31/1982
- Affected:
- 15,495
- Defect:
- Rear brake hoses may have been manufactured incorrectly when the metal end fittings were installed. some rear brake hoses may separate from the metal end fittings when subjected to the pulling force specified by federal motor vehicle safety standard 106, "brake hoses".
- Correction:
- The dealer will inspect and replace, if necessary, the rear brake hoses at no charge to owners.
- Notes:
- Vehicle description: passenger vehicles.system: service brakes; rear brake hoses.consequences of defect: a separation may result in a loss of brake fluid and apartial loss of braking action. a partial loss of braking action could resultin a vehicle crash in situations in which a minimum stopping distance isrequired.
Home | Privacy