1980 CHEVROLET CITATION Recalls (9)

Campaign:
79V098000 on 10/11/1979
Component:
Suspension:front:springs:coil springs
Manufactured:
07/31/1978 - 02/28/1979
Affected:
23,725
Defect:
The front suspension coil spring may have a larger than desired inside diameter of the lower coil where it rests on the spring seat. this could allow the spring to be forced over the lower spring seat due to suspension forces.
Correction:
Dealer will inspect and replace incorrect front suspension coil springs without charge.
Notes:
Vehicle description: passenger vehicles.system: suspension; front coil.consequences of defect: this condition would cause brake hose and suspensiondamage. tire damage may also occur with continued vehicle operation. damage toany of these components could cause loss of vehicle control and an accident.

Campaign:
79V090000 on 10/11/1979
Component:
Service brakes, hydraulic:foundation components:hoses, lines/piping, and fittings
Manufactured:
07/31/1978 - 02/28/1979
Affected:
4,382
Defect:
There is a potential for interference between the clutch control cable and brake pipe in the master cylinder. this can result in rubbing contact when the clutch pedal is operated. also, the brake pipe clearance to the transmission case may be inadequate. if this condition exists, it could eventually result in a failure in the brake pipe, causing loss of brake fluid and partial loss of braking action.
Correction:
The clutch cable routing will be revised to prevent contact with the master cylinder, without charge.
Notes:
Vehicle description: passenger vehicles.system: power train; clutch assembly.consequences of defect: should a partial loss of braking action occur while thevehicle is in motion at a time when minimum stoping distance is required, anaccident would result.

Campaign:
79V073000 on 10/11/1979
Component:
Seats
Manufactured:
12/31/1978 - 01/31/1979
Affected:
35
Defect:
Vehicles do not comply to federal motor vehicle safety standard no. 207, "anchorage of seats". the lock bar in the front seat adjuster assemblies may not engage properly and the ability of the seat adjuster to maintain the seat in a latched position during an accident may be reduced.
Correction:
Both front seat adjuster assemblies will be replaced at no charge to owner.
Notes:
Vehicle description: passenger vehicles.system: interior; front seat adjuster assembly.consequences of defect: in the event of an accident, the risk of injury topassengers will be increased.

Campaign:
79V091000 on 10/11/1979
Component:
Fuel system, gasoline:delivery:hoses, lines/piping, and fittings
Manufactured:
07/31/1978 - 02/28/1979
Affected:
4,626
Defect:
Fuel hoses may be incorrectly positioned and contact the right front drive axle boot during vehicle operation. after a period of time, the rotating boot could wear a hole in the fuel hose, resulting in fule leakage.
Correction:
If proper clearance is not present, the metal fuel pipe will be reformed upwards to correct the problem, without charge to owner.
Notes:
Vehicle description: passenger vehicles.system: fuel; fuel hose.consequences of defect: leaking fuel could lead to a fire in the enginecompartment, vehicle damage, and personal injury to passengers.

Campaign:
79V092000 on 10/11/1979
Component:
Structure:frame and members
Manufactured:
07/31/1978 - 02/28/1979
Affected:
10,751
Defect:
The longitudinal body bars at the rear control arm location may not have been adequately welded into the structure. some of these bars may have been pulled down from the body during shipment with resulting damage to the brake or fuel lines. separation of the control arm attachment may also result.
Correction:
Longitudinal body bars will be welded and bolted in the proper position without charge to owner.
Notes:
Vehicle description: passenger vehicles.system: suspension; longitudinal body bars.consequences of defect: separation of the control arm attachment or damage tothe brake line could cause loss of vehicle control and an accident. fuel linedamage may lead to a vehicle fire and personal injury to passengers.

Campaign:
79V220000 on 12/11/1979
Component:
Power train:automatic transmission:cooling unit and lines
Manufactured:
12/31/1978 - 07/31/1979
Affected:
224,892
Defect:
The automatic cooler line hoses on some of the suspect vehicles may contain material voids, which combined with a high thermal expansion at elevated temperatures, could result in hose failure and transmission fluid leakage.
Correction:
The dealer will replace the cooler line hoses using hoses with kevlar braided reinforcement.
Notes:
Vehicle description: passenger vehicles.system: power train; transmission hoses.consequences of defect: a vehicle fire may result which could cause seriouspersonal injury.

Campaign:
79V221000 on 12/11/1979
Component:
Steering:rack and pinion
Manufactured:
12/31/1978 - 05/31/1979
Affected:
161,225
Defect:
The steering gear mounting plate on the involved vehicles may develop fatigue cracks at high mileage which would allow the steering gear attachment to become loose. if this condition exists, the driver may notice considerable "free play" in the steering wheel.
Correction:
The dealer will install an improved type of steering gear mounting bracket without charge to owner.
Notes:
Vehicle description: passenger vehicles.system: steering; gear mounting bracket.consequences of defect: this condition may result in degradation of steeringcontrol, which could lead to loss of vehicle control and an accident.

Campaign:
81V095000 on 08/11/1981
Component:
Service brakes, hydraulic:foundation components:differential proportional valve
Manufactured:
07/31/1978 - 07/31/1979
Affected:
47,371
Defect:
Under certain conditions, the rear brakes could lock up without prior warning during high deceleration braking. the problem may be caused by defective proportioner valves in the braking system.
Correction:
The dealer will inspect the brake system proportioner valves and if necessary install new valves.
Notes:
Vehicle description: passenger vehicles with manual transmissions.system: service brakes; rear brakes.consequences of defect: rear brake lockup could cause a loss of vehicle controland an accident.

Campaign:
83V018000 on 02/27/1983
Component:
Service brakes, hydraulic:foundation components
Manufactured:
12/31/1978 - 06/30/1980
Affected:
239,799
Defect:
Under certain conditions, vehicles may experience premature rear wheel skid during braking. rear wheel skidding is most likely to occur on a wet or slick surface.
Correction:
Depending on the transmission type and the brake components that have been installed, dealers will inspect and replace or repair, as necessary, certain front brake components, and the parking brake cables. the rear brake shoes and linings will be replaced with parts that use a material which greatly reduces the likelihood of rear wheel skid. actions taken to the front brakes are to ensure uniformity of the entire brake system. actions taken to the parking brake components will ensure that the performance requirements, for keeping the vehicle stationary while manual transmission equipped units are in neutral and automatic transmission equipped units are in park, are met.
Notes:
Vehicle description: passenger vehicles.system: service brakes; rear brakes.consequences of defect: if the driver is unable to complete corrective steeringor braking actions, the rear end of the vehicle may skid out of its lane oftravel, possibly resulting in an accident.note: until the problem is corrected, the driver should use caution in makinghard braking stops.

Home | Privacy