1978 GILLIG GILLIG Recalls (6)
- Campaign:
- 78V050000 on 10/11/1979
- Component:
- Service brakes, air:drum:shoes/linings
- Affected:
- 812
- Defect:
- The brake shoe welds on rear brake assemblies may loosen where the brake shoe web joins the brake shoe table. complete brake shoe failure could result on the axle side affected.
- Correction:
- Dealer will replace defective brake shoe assemblies without charge.
- Notes:
- Vehicle description: school buses.system: service brakes; brake shoes.consequences of defect: failure of the brake shoe assembly could lead to lossof vehicle control without prior warning and an accident.note: until replacement of defective assemblies is completed, brake shoeassemblies should be inspected at frequent intervals for evidence of weldcracking or failure. dealer should be contacted immediately if such evidence isfound.
- Campaign:
- 78V154000 on 10/11/1979
- Component:
- Service brakes, air:drum:shoes/linings
- Manufactured:
- 07/31/1977 - 05/31/1978
- Affected:
- 81
- Defect:
- The brake shoe welds on the rear brake assemblies could loosen where the brake shoe web joins the brake shoe table. this loosening can result in complete brake shoe failure on the axle side affected. some braking capability should be maintained since the front braking assembly is not affected.
- Correction:
- The dealer will replace the defective brake shoe assemblies free of charge.
- Notes:
- Vehicle description: transit buses.system: service brakes; rear brake assemblies.consequences of defect: partial loss of braking capability could result in lossof vehicle control and an accident.
- Campaign:
- 79V088000 on 10/11/1979
- Component:
- Suspension:rear:springs:leaf spring assembly:hanger/bracket
- Manufactured:
- 12/31/1977 - 01/31/1979
- Affected:
- 123
- Defect:
- A casting deficiency in the rear axle front spring hanger may result in cracks around the four bolts that hold the hanger to the frame. this may cause a failure of the spring hanger and separation of casting and frame. continued operation could result in the bus body dropping down onto the tire.
- Correction:
- Defective spring hangers will be replaced without charge to owner.
- Notes:
- Vehicle description: school buses.system: suspension; rear axle front spring hangers.consequences of defect: this defect may cause loss of vehicle control and anaccident.note: as a precaution, visually inspect the area where the bolts attach thehanger to the frame. if hanger is cracked, do not operate vehicle untilcorrective action is taken. the driver may be warned of trouble by a sound atthe instant of hanger separation.
- Campaign:
- 80V011000 on 03/06/1980
- Component:
- Seats
- Manufactured:
- 03/31/1977 - 06/30/1978
- Affected:
- 198
- Defect:
- The restraining barriers on the involved vehicles do not conform to federal motor vehicle safety standard no. 222, "school bus passenger seating and crash protection". due to improper alignment, the barrier mounting bolts may not be secured through the floor tapping strip.
- Correction:
- The dealer will add lock nuts to the restraining barrier mounting bolts at no charge to owner.
- Notes:
- Vehicle description: school buses.system: structure; restraining barriers, mounting bolts.consequences of defect: in the event of an accident, the barrier might notadequately restrain the occupants in the seat immediately to the rear of thebarrier, which would increase the chances of injury.note: the defect may be detected by visual inspection of the curb-side barrierfloor attachment bolts, from the underside of the vehicle.
- Campaign:
- 81V006000 on 02/11/1981
- Component:
- Equipment:other:labels
- Manufactured:
- 08/31/1977 - 01/31/1979
- Affected:
- 367
- Defect:
- Tire pressure and rim size information may have been omitted from the vehicle tire information plate that is mounted in the driver"s compartment.
- Correction:
- Corrected information plates will be supplied by manufacturer without cost to owner.
- Notes:
- Vehicle description: school buses and transit buses.system: labels; information and certification.consequences of defect: lack of proper information may cause over orunder-inflation of tires, which can lead to air loss and, possibly, loss ofvehicle control and an accident.
- Campaign:
- 81V018000 on 03/17/1981
- Component:
- Structure:body
- Manufactured:
- 03/31/1977 - 09/30/1979
- Affected:
- 474
- Defect:
- On certain vehicles, the joints used to attach a rear settee trim panel may not meet the 60 percent joint strength requirement of federal motor vehicle safety standard no. 221, "school bus body joint strenght".
- Correction:
- Additional fasteners will be added at the non-complying joints to ensure compliance with the applicable safety standard. this service will be performed without charge.
- Notes:
- Vehicle description: school buses.system: interior; rear seat trim panel.consequences of defect: in the event on an accident, if the joints do not meetthe 60 percent joint strength as specified in the safety standard, thestructure could collapse, causing personal injury to passengers and, in extremecases death.
Home | Privacy