1974 FORD L800 Recalls (3)
- Campaign:
- 78V153000 on 10/11/1979
- Component:
- Engine and engine cooling:cooling system:fan
- Manufactured:
- 07/31/1970 - 08/31/1977
- Affected:
- 125,000
- Defect:
- The engine cooling fan blades may crack and chip due to high stresses caused by vibrations. the chipped pieces of the blade could fly into the underhood components. also, these pieces could fly out from the vehicle if the hood is open and the engine is running.
- Correction:
- The dealer will replace the existing fan blade assembly with one of another design at no cost to owner.
- Notes:
- Vehicle description: heavy trucks.system: engine cooling; fans.consequences of defect: the blade fragments could cause engine damage and, ifhood is open, serious personal injury to nearby persons.
- Campaign:
- 77V191000 on 10/11/1979
- Component:
- Seat belts:front:anchorage
- Manufactured:
- 12/31/1971 - 08/31/1977
- Affected:
- 6,500
- Defect:
- The seat belts on the involved vehicles fail to conform to federal motor vehicle safety standard nos. 208, "occupant crash protection", and 209, "seat belt assemblies". the non-conformity exists because when the driver"s seat is adjusted to the full forward position, the seat cushion is adjusted to maximum elevation, and the seat back is tilted to the fully upright position, the seat belts are not long enough to accommodate some drivers.
- Correction:
- Dealer will replace any seat belt assembly that is determined to be insufficient, without charge to owner.
- Notes:
- Vehicle description: heavy trucks equipped with bostrom "levelaire" or national"cushion aire" adjustable driver seats and standard seat belts.system: interior; seat belt assemblies.consequences of defect: in the event of an accident, lack of seat beltprotection could result in serious injury to the driver.
- Campaign:
- 75V072000 on 10/11/1979
- Component:
- Power train:automatic transmission
- Affected:
- 560
- Notes:
- Ford campaign no 157.heavy duty trucks.possibility that vehicles equippedwith mt-650 automatic transmission may contain nylon particles contaminantwithin the transmission governor assembly.a nylon particle could block anorifice in the governor valve and result in unintentional transmissiondownshift with the possibility of transmission disintergration.(correct byinspecting and replacing governor assembly where necessary).