1973 OLDSMOBILE OMEGA Recalls (4)

Campaign:
74V027000 on 10/11/1979
Component:
Service brakes, hydraulic:power assist:vacuum
Affected:
1,218,387
Notes:
Oldsmobile campaign no 74-c-5.buick campaign no 73-c-3.gmc truck campaignno 74-c-06.chevrolet campaign no 74-c-11.pontiac campaign no 74-c-5.possibility that the single diaphragm brake vacuum power booster was assembledwith demensional descrepancies in the vacuum power booster housing which mayreduce the torque required to unlock the front half of the housing from therear half.if this condition exists, the low unlocking torque coupled withother variations in the assembly may cause housing to rotate and disengage fromthe locking tabs resulting in separation of the two halves of the booster andcomplete loss of brakes.(correct by inspecting and staking the housing at twopoints to preclude rotation of the housing.

Campaign:
72V305000 on 10/11/1979
Component:
Seat belts:front:warning light/devices
Manufactured:
07/31/1972 - 09/30/1972
Affected:
3,225
Notes:
General motors campaign no (chevy) 73-c-07 (pontiac) 73-c-05 (oldsmobile)73-c-3.vehiles equipped with 3 speed transmission and column shift.possibility that seat belt warning system will not function with vehicle inthird gear due to rotation of shift tube not always making contact with seatbelt warning system relay.(correct by inspecting and installing redesignedshift rod and new shift levers.)

Campaign:
72V290000 on 10/11/1979
Component:
Suspension:front:control arm:upper arm
Manufactured:
10/31/1972 - 10/31/1972
Affected:
330
Notes:
Possibility that left front upper control arm attaching nut was improperlytorqued.condition could result in nut becoming loose allowing bolt to workand eventually break, causing loss of steering control.(correct by inspectingand torquing properly where necessary.)

Campaign:
72V265000 on 10/11/1979
Component:
Steering:linkages
Manufactured:
09/30/1972 - 09/30/1972
Affected:
544
Notes:
General motor campaign no 73-c-1.(vehiles equipped with optional front discbrakes).possibility that steering arm to caliper anchor bracket attachingbolts were improperly torqued.low torque could cause bolt to break, if thisoccurs, broken bolt could come outof position and lodge in right hand frontbrake rotor resultingin sudden lockup of tire and wheel assembly.(correct byinspecting and torquing bolt to specified 60 to 80 lb.ft.)

Home | Privacy